n-FAB INST-00294 Hoop Step Instruction Manual

June 13, 2024
n-FAB

N-FAB Pro Truck Products Logo-Vector

n-FAB INST-00294 Hoop Step

n-FAB-INST-00294-Hoop-Step-product

Product Information

Hardware Description:

QTY. Part Number Description
18 FLNT00696X FDRW00736X M8-1.25 CLASS 8 SERRATED FLANGE NUT
18 M8 FENDER WASHER
12 10MM flanged nut
12 10MM Carriage bolt

Parts Included:

QTY Description
1 DRIVER SIDE STEP
1 PASSENGER SIDE STEP
12 Mounting Brackets

I-SHEET INFORMATION:

  • Part Number: INST-00294
  • Product: HOOP STEP
  • Application: RAM 1500 QC

Product Usage Instructions

  • Step 1: Identify the driver-side step.
  • Step 2: Install the (x6) mounting brackets to each attachment point on the main tube and leave them loose for now. Note the bracket orientation. The front bracket should bend towards the front of the vehicle.
  • Step 3: After final adjustment, tighten (x3) brackets to a torque of 20 ft./lbs.
  • Step 4: Next, tighten (x3) mounting brackets at the main tube to a torque of 20-25 ft./lbs.
  • Step 5: Repeat steps 2-4 for the passenger side.

HARDWARE DESCRIPTION

HARDWARE DESCRIPTION QTY.
 

FLNT-

00696X

| M8-1.25 CLASS 8 SERRATED FLANGE

NUT

| 18
FDRW-

00736X

| M8 FENDER WASHER| 18
 | 10MM flanged nut| 12
 | 10MM Carriage bolt| 12

PARTS INCLUDED

PARTS INCLUDED

|

QTY

---|---
DRIVER SIDE STEP| 1
PASSENGER SIDE STEP| 1
Mounting Brackets| 12

Identify driver-side step

n-FAB-INST-00294-Hoop-Step-fig- \(1\)

Installation Instruction

  • Step 1: Install the (x6) mounting brackets to each attachment point on the main tube and leave them loose for now. Note the bracket orientation. The front bracket bends towards the front of the vehicle.n-FAB-INST-00294-Hoop-Step-fig- \(2\)
  • Step 2: Starting with the driver’s side, remove any steps and old hardware from the vehicle.n-FAB-INST-00294-Hoop-Step-fig- \(3\)
  • Step 3: On the inside rocker panel there will be three attachment points consisting of three 8mm studs coming out from the panel. These studs may be covered in paint and will need to be cleaned before the installation.
  • Step 4: An additional person is recommended for this step. Carefully install the Hoop step to the three factory attachment points using the provided M8 flanged hex nuts. Leave your finger tight for now.
  • Step 5: After final adjustment, tighten (x3) bracket to (20 ft./lbs of torque.)
  • Step 6: Next, tighten (x3) mounting brackets at the main tube ( 20-25 ft./lbs torque.)
  • Step 7: Repeat steps 1-6 for the passenger side.

Contact Information

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals