n-FAB RAM 1500 CC Hoop Step Instruction Manual
- June 13, 2024
- n-FAB
Table of Contents
n-FAB RAM 1500 CC Hoop Step
Product Information
- I-SHEET PART NUMBER: INST-00288
- PART NUMBER: 219418012
- PRODUCT: HOOP STEP
- APPLICATION: RAM 1500 CC
Note: The driver-side step is to be identified.
Product Usage Instructions
Step 1
Install the (x6) mounting brackets to each attachment point on the main tube and leave them loose for now. Note the bracket orientation. The front bracket should bend towards the front of the vehicle.
- I-SHEET PART NUMBER: INST-00288
- PART NUMBER: 219418012
- PRODUCT: HOOP STEP
- APPLICATION: RAM 1500 CC
HARDWARE DESCRIPTION
| QTY.
---|---
|
FLNT-
00696X
| M8-1.25 CLASS 8 SERRATED FLANGE
NUT
| 18
FDRW-
00736X
| M8 FENDER WASHER| 18
| 10MM flanged nut| 12
| 10MM Carriage bolt| 12
PARTS INCLUDED
|
QTY
---|---
DRIVER SIDE STEP| 1
PASSENGER SIDE STEP| 1
Mounting Brackets| 12
Identify driver-side step
Step 1: Install the (x6) mounting brackets to each attachment point on the main tube and leave them loose for now. Note the bracket orientation. The front bracket bends towards the front of the vehicle.
Step 2: Starting with the driver’s side, remove any steps and old hardware from the vehicle.
Step 3: On the inside rocker panel there will be three attachment points consisting of three 8mm studs coming out from the panel. These studs may be covered in paint and will need to be cleaned before the installation.
Step 4: An additional person is recommended for this step. Carefully install the Hoop step to the three factory attachment points using the provided M8 flanged hex nuts. Leave your finger tight for now.
Step 5: After final adjustment, tighten (x3) bracket to (20 ft./lbs of
torque.)
Step 6: Next, tighten (x3) mounting brackets at the main tube ( 20-25
ft./lbs torque.)
Step 7: Repeat steps 1-6 for the passenger side.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>