n-FAB HPD0973QC-TX Cab Length Podium Step Nerf Bars Installation Guide
- June 13, 2024
- n-FAB
Table of Contents
n-FAB HPD0973QC-TX Cab Length Podium Step Nerf Bars
HARDWARE DESCRIPTION
HARDWARE DESCRIPTION | QTY. |
---|---|
M8 bolt plate | 6 |
M8 serrated flanged nut | 6 |
M8 lock washer | 12 |
M8 flat washer | 18 |
M8 bolt | 12 |
M8 u-nit | 12 |
10mmx25mm Carriage bolt | 12 |
10mm Hex Flanged Nut | 12 |
PARTS INCLUDED
PARTS INCLUDED | QTY |
---|---|
Driver side step | 1 |
Passenger side step | 1 |
Mounting Bracket | 6 |
INSTALLATION INSTRUCTIONS
Step 1. Identify Driver side step.
Step 2. Install the (x6) mounting brackets to each attachment point on
the main tube using the supplied M10x25 carriage bolts, M10 hex nuts and leave
loose for now.
** NOTE: The brackets will attach to the backside of the mounting flange
with the threaded end of the carriage bolt facing towards the REAR of the
step. *****
Step 3. Remove OE boards if equipped and discard. Next, locate mounting holes and insert the supplied U-nuts at the bottom two holes.
Step 4. Place clear retainer over stud and bolt plate. Fish bolt plate through the body of the vehicle and slide retainer tight to stud. Take your time here to avoid dropping bolt plate in the body.
Step 5. Carefully hold step into place. Hand tighten the upper nut to bolt plate with washer. An assistant is recommended in the step. Insert and hand tighten lower bolt.
Step 6. Begin tightening nuts and bolts in an alternating pattern. Tighten to 20 (ft./lbs.) torque securing the steps to the vehicle.
Step 7. After finial adjustment, tighten all three brackets at the main tube.
Step 8. Re-peat step 3-7 for passenger side install.
I-SHEET PART NUMBER: INST-00315
PART NUMBER: HPD0973QC-TX
PRODUCT: POIDIUM STEP
APPLICATION: 09-14 1500-4500 RAM QUAD CAB
CUSTOMERS SUPPORT
12302 Shiloh Church Rd. Houston TX 77066 Phone 281-880-6322 – Fax 281-880-6325
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>