n-FAB HWKT-05321X Nerf Step System with Drop Down Hoop Installation Guide
- June 13, 2024
- n-FAB
Table of Contents
n-FAB HWKT-05321X Nerf Step System with Drop Down Hoop
HARDWARE DESCRIPTION
HARDWARE DESCRIPTION | QTY. |
---|---|
KIT# HWKT-05321X | |
M8x30mm flanged hex bolt with washer | 6 |
M8x25mm Flanged hex head bolt ( Black zinc) | 8 |
M8 flanged nuts | 8 |
M10X25mm Carriage bolt | 12 |
M10 hex nut | 12 |
PARTS INCLUDED
PARTS INCLUDED | QTY |
---|---|
Driver Side step | 1 |
Passenger side step | 1 |
Mounting bracket | 6 |
INSTALLATION INSTRUCTIONS
Step 1: Locate the driver side step rail.
Step 2. Install the (x6) mounting brackets to each attachment point on
the main tube and leave loose for now.
** NOTE: The brackets will attach to the backside of the mounting flange
with the threaded end of the carriage bolt facing towards the REAR of the
step. *****
Step 3. Remove the factory running boards and discard.
Step 4. Carefully raise step up into position and align the brackets with
the factory mounting points with the horizontal part of the bracket on the
outside of the pinch weld.
Step 5. Next, start one of the supplied M8x30mm hex head flanged bolts
starting with the center bracket in the factory threaded hole and leave loose.
Step 6. Install two supplied M8x25mm black zinc flanged bolts and two M8
flanged nuts in the pinch weld mounts in the front and rear brackets and leave
loose.
Step 7. First, tighten all the hardware that attaches the bracket to the pinch weld of the vehicle.
Step 8. Next, tighten the remaining hardware that attaches the bracket to the upper body mount.
Step 9: After finial adjustment, tighten all three brackets at the main tube.
Step 10. Repeat steps 2-9 for the passenger side.
I-SHEET NUMBER: INST-00257
PART NUMBER: HPJ1980T-TX, HPJ1980T-SS
PRODUCT: HOOP STEP
APPLICATION: JEEP JT TRUCK 4D
CUSTOMERS SUPPORT
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>