n-FAB HPC1473QC Podium Hoop Step Instruction Manual
- June 13, 2024
- n-FAB
Table of Contents
I-SHEET NUMBER: INST-00310
PART NUMBER: HPC1473QC, HPC1495QC-6
PRODUCT: PODIUM HOOP STEP
APPLICATION: 14-18 CHEVY/GM QC
n-fab.com nfabinc
HARDWARE DESCRIPTION|
QTY.
---|---
HWKT-00424X|
1
M8 Threaded clip|
6
M8-1.25 Hex fin Nut|
6
M8-1.25x25mm Hex head bolt|
12
M10 fender washer|
18
M10X25mm Carriage bolt|
12
M10 hex nut|
12
PARTS INCLUDED|
QTY
---|---
DRIVER SIDE|
1
PASSENGER SIDE|
1
MOUNTING BRACKET|
6
DO NOT USE IMPACT TOOLS
Step 1: Identify Driver side step
DRIVER
DRIVER
Step 2: Install the (x6) mounting brackets to each attachment point on
the main tube using the supplied M10x25 carriage bolts, M10 hex nuts and leave
loose for now.
** NOTE: The brackets will attach to the backside of the mounting flange
with the threaded end of the carriage bolt facing towards the REAR of the
step. *****
- REAR
- FRONT
Step 3: Look on the underside of the body and locate the factory supplied mounting positions. NOTE: Some vehicles require the use of speed clips and nuts, which are supplied with the hardware kit.
Step 4: If your vehicle requires the use of the speed clips, install at this time. This requires the removal of a plastic body plug. Using a flat head screwdriver remove the plug and install one of the supplied speed clips.
Step 5: Install the Nerf Step to the mounting locations in the body of the vehicle and install hardware. Do not tighten all the way. NOTE: Some vehicles may require the use of additional nuts and washers for the lower portion of the mounting bracket which are supplied in the hardware kit
Step 6: Next, tighten all hardware beginning with the lower mounts first then the upper mounting locations.
Step 7: After finial adjustment, tighten all three brackets at the main tube.
Step 8: Repeat steps 2-7 with passenger side. Your install is now complete.
12302 Shiloh Church Rd. Houston TX 77066 Phone 281-880-6322 – Fax 281-880-6325
REVISION – – © 2018 N-FAB, INC. REVISION DATE 08/01/19