n-FAB HPF9973QC-TX Hoop Step Installation Guide
- June 13, 2024
- n-FAB
Table of Contents
n-FAB HPF9973QC-TX Hoop Step
HARDWARE DESCRIPTION
HARDWARE DESCRIPTION | QTY. |
---|
HWKT-07323X
HHCS-00568X| 3/8″-16 X 1″| 6
FLTW-00663X| 3/8″ USS FLAT WASHER| 12
CLIP-00646X| 3/8″-16 X 3/4″ BARREL NUT CLIP| 6
CARB-00680X| 3/8″-16 X 1-1/2″ GRADE 5 CARRIAGE| 6
HXNT-00717X| 3/8″-16 GRADE 5 FINISHED HEX NUT| 6
| M10 CARRIAGE BOLT| 12
| M10 FLANGED HEX NUT| 12
PARTS INCLUDED| QTY
---|---
Driver Side step| 1
Passenger side step| 1
Mounting Bracket| 12
Instruction for use
STEP 1 : Identify driver side step.
Step 2 Using the supplied M10 carriage bolt and nut, install the (x6)
mounting brackets to each attachment point on the main tube and leave loose
for now.
** NOTE:** The brackets will attach to the backside of the mounting flange
with the threaded end of the carriage bolt facing towards the REAR of the
step. ***
Step 3 : Locate the holes for the upper mounts (x3) and install the
supplied (x2) 3/8” clips in each position. NOTE: There will be four attachment
points for the Quad Cab and five for the Crew Cab.
Only three will be used for the installation. See below for your cab
configuration.
Quad Cab
Step 4 : Next, install the step aligning the brackets to the upper clips
using the 3/8”x1” Hex bolt, 3/8’
USS Flat washer for the upper attachment and the 3/8”x 1 ½” carriage bolt 3/8”
Hex nut and 3/8”
USS washer for the lower attachment. Leave loose for now. NOTE: The carriage
bolts will start from the outside of the body, the nut and washer will be only
visible from underneath the vehicle.
Step 5 : After finial adjustment, tighten all hardware to 17-20 ft/lbs of
torque.
Step 6 : Next, tighten (x3) mounting bracket at the main tube.
Step 7 : Repeat steps 3-6 for passenger side install.
12302 Shiloh Church Rd. Houston TX 77066 Phone
281-880-6322 – Fax
281-880-6325
REVISION – – © 2018 N-FAB, INC. REVISION DATE 11/14/19
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>