n-FAB HPC1980CC-TX Podium Hoop Step Installation Guide

June 13, 2024
n-FAB

n-FAB HPC1980CC-TX Podium Hoop Step

n-FAB HPC1980CC-TX Podium Hoop Step

HARDWARE DESCRIPTION

HARDWARE DESCRIPTION QTY.
# HWKT-03054X
M8X30mm Hex Cap with washer 12
M10X25mm Carriage bolt 12
M10 hex nut 12
PARTS INCLUDED QTY
--- ---
Driver Side step 1
Passenger side step 1
Mounting Bracket 6

DO NOT USE IMPACT TOOLS

Instruction for use

Step 1: Locate the driver side step rail.

Instruction for use

Instruction for use

Step 2 Install the (x6) mounting brackets to each attachment point on the main tube and leave loose for now.
** NOTE:** The brackets will attach to the backside of the mounting flange with the threaded end of the carriage bolt facing towards the REAR of the step. ***

Instruction for use

Step 3 Carefully raise the Nerf Step up into position aligning the mounting brackets with the factory-threaded holes. Beginning with the center bracket start one of the supplied M8x30mm Hex bolts in the upper mount and finger tighten. This will allow the Nerf step to be suspended while you start the reminder of the hardware.
Step 4 Next, start all remainder hardware in the factory locations and leave loose.

Step 5 After final adjustment fully tighten (x3) brackets to the factory body mounts.
Step 6 Next, fully tighten (x3) brackets to the mounting flanges on the main tube.
Step 7 Repeat steps 3-6 for the passenger side.

Instruction for use

Logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals