BRExhaust 106-0156 Direct-Fit Exhaust System Instruction Manual

BRExhaust 106-0156 Direct-Fit Exhaust System

Product Information

• Product Name: Exhaust System
• Model Number: 106-0156
• Manufacturer: BRExhaust
• Installation Type: Replacement
• Recommended Installation: Professional installation
• Technical Support: 1-800-631-7271
• Manufacturer Address: 1901 Corporate Ctr, Oceanside, CA 92056
• Manufacturer Website: www.brexhaust.com.

Product Usage Instructions

1. Disconnect the vehicle’s battery before removing the OEM exhaust system to prevent electrical accidents and reset the computer if applicable.
2. Remove the existing exhaust system from the vehicle, only removing the parts that will be replaced.
3. Clean the existing flange with a wire brush to ensure proper sealing.
4. Attach item 5 to the existing isolators.
5. Connect item 3 to the existing isolators and exhaust using items 1 and 2.
6. Using item 4, connect item 5 to item 3.
7. Attach the clamp provided with item 3 to secure the slip-fit joint.
8. Ensure that the new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
9. Tighten all clamps and bolts starting from the rear of the vehicle. Do not exceed 30ft-lb when tightening the clamp. Check all clamps after driving 50 miles and retighten if necessary.

Warning:

• When working on, under, or around any vehicle, exercise caution.
• Allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns.
• If working without a lift, always consult the vehicle manual for correct lifting specifications.
• Always wear safety glasses and ensure a safe work area.
• Serious injury or death could occur if safety measures are not followed.

WARNING:
When working on, under, or around any vehicle exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult the vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.

INSTALLATION INSTRUCTIONS

• STEP 1:
  (Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove the existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean the existing flange with a wire brush to ensure proper sealing.

• STEP 2:
  Attach item 5 to existing isolators

• STEP 3:
  Connect item 3 to existing isolators and exhaust using items 1 and 2

• STEP 4:
  Using item 4 connect item 5 to item 3

• STEP 5:
  Attach the clamp provided with item 3 to secure slip slip-fit joint

• STEP 6:
  Ensure new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.

• STEP 7:
  Tighten all clamps and bolts starting from the rear of the vehicle. (DO NOT EXCEED 30FT-LB WHEN TIGHTENING THE CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY).

BRExhaust recommends professional installation for all products.

Contact Information

• Technical Support: 1-800-631-7271
• BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056.
• www.brexhaust.com.

References

• MagnaFlow Exhaust, Mufflers & Cat Converters - Quality. Power. Sound.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>