BRExhaust 106-0146 Muffler Kit Instruction Manual

: June 13, 2024
: BRExhaust

Table of Contents

BRExhaust 106-0146 Muffler Kit
Product Information
INSTALLATION INSTRUCTIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

BRExhaust 106-0146 Muffler Kit

Product Information

Installation Instructions

Part No. 106-0146

(Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove the existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean the existing flange with a wire brush to ensure proper sealing.

Step 1:

Disconnect the vehicle’s battery before removing the OEM exhaust system. This step is important to prevent electrical accidents and to reset the computer if applicable to the vehicle. Remove only the parts of the existing exhaust system that will be replaced. Clean the existing flange with a wire brush to ensure proper sealing.

Step 2:

Begin installation by installing item 3 to the existing exhaust using item 1 and item 2.

Step 3:

Attach item 5 to the existing isolators and use item 4 to connect item 3.

Step 4:

Attach item 7 to the existing isolator.

Step 5:

Attach item 6 to item 5 and item 7 using item 4.

Step 6:

Ensure the new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.

Step 7:

Tighten all clamps and bolts starting from the rear of the vehicle. Do not exceed 30 ft-lb when tightening the clamp. Check all clamps after 50 miles and retighten if necessary.

WARNING: When working on, under, or around any vehicle, exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult the vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.

BRExhaust recommends professional installation for all products.

Contact Information

Technical Support: 1-800-631-7271
BRExhaust: 1901 Corporate Ctr, Oceanside, CA 92056
Website: www.brexhaust.com

INSTALLATION INSTRUCTIONS

WARNING:

When working on, under, or around any vehicle exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult the vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.

STEP 1: (Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove the existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean the existing flange with a wire brush to ensure proper sealing.

STEP 2: Begin installation by installing item 3 to existing exhaust using item 1 and item 2

STEP 3: Attach item 5 to existing isolators and use item 4 to connect item 3

STEP 4: Attach item 7 to existing isolator

STEP 5: Attach item 6 to item 5 and item 7 using item 4

STEP 6:
Ensure new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.

STEP 7: Tighten all clamps and bolts starting from the rear of the vehicle. (DO NOT EXCEED 30FT-LB WHEN TIGHTENING THE CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)

BRExhaust recommends professional installation for all products

Technical Support: 1-800-631-7271