BRExhaust 106-0132 Muffler Kit Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 106-0132 Muffler Kit
INSTALLATION INSTRUCTIONS
PART NO. 106-0132
STEP 1 :
(Carefully read all instructions before installation) Disconnect the vehicle’s
battery before removal of the OEM exhaust system. This will prevent electrical
accidents and will reset the computer if it applies to the vehicle. Remove
existing exhaust system from the vehicle. Only remove parts that will be
replaced. Clean existing flange with a wire brush to ensure proper sealing.
STEP 2 :
Attach item 5 to existing isolators and install clamp(s) provided with item 5
STEP 3 :
Attach extension pipe (item 2 or 3) with item 1 to existing exhaust. If using
item 2, install clamp(s) provided
STEP 4 :
Place item 4 between extension pipe and item 5
STEP 5 :
Place item 1 between items 4 and 5
STEP 6 :
Place item 1 between extension pipe and item 4
STEP 7 :
Ensure new exhaust is not contacting any portion of the underbody of the
vehicle or drivetrain.
STEP 8 :
Tighten all clamps starting from rear of the vehicle. (DO NOT EXCEED 30FT-LB
WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF
NECESSARY)
WARNING:
When working on, under, or around any vehicle exercise caution.
Please allow the vehicle’s exhaust system to cool before removal, as exhaust
temperatures may cause severe burns. If working without a lift, always consult
vehicle manual for correct lifting specifications.
Always wear safety glasses and ensure a safe work area. Serious injury or
death could occur if safety measures are not followed.
BRExhaust recommends professional installation for all products
Customer Support
Technical Support: 1-800-631-7271
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
http://www.brexhaust.com/
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>