BRExhaust 106-0022 Muffler Kit Owner’s Manual
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 106-0022 Muffler Kit
Product Information
The product is an exhaust system designed to replace the OEM exhaust system in a vehicle. It is manufactured by BRExhaust and the part number is 106-0490. The exhaust system is made up of various components, including item 1, item 2, item 3, item 4, item 5, and item 6. It is important to follow the installation instructions carefully to ensure proper installation and functionality of the exhaust system.
Product Usage Instructions
- Disconnect the vehicle’s battery before removing the OEM exhaust system to prevent electrical accidents and reset the computer if applicable.
- Remove the existing exhaust system from the vehicle, only removing the parts that will be replaced.
- Clean the existing flange with a wire brush to ensure proper sealing.
- Attach item 2 to the existing exhaust using item 1.
- Attach item 4 to the existing isolators and item 2 using item 3.
- Attach item 6 to the existing isolators and item 4 using item 5.
- Connect item 6 slip fit with the provided clamp.
- Ensure that the new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
- Tighten all clamps starting from the rear of the vehicle. Donot exceed 30ft-lb when tightening the clamp. Check all clamps after driving 50 miles and retighten if necessary.
INSTALLATION INSTRUCTIONS
STEP 1: (Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean existing flange with a wire brush to ensure proper sealing.
STEP 2: Attach item 2 to existing exhaust with item 1
STEP 3: Attach item 4 to existing isolators and item 2 with item 3
STEP 4: Attach item 6 to existing isolators and item 4 with item 5
STEP 5: Connect item 6 slip fit with clamp provided
STEP 6: Ensure new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
STEP 7: Tighten all clamps starting from rear of the vehicle. (DO NOT EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)
WARNING:
When working on, under, or around any vehicle exercise caution. Please
allow the vehicle’s exhaust system to cool before removal, as exhaust
temperatures may cause severe burns. If working without a lift, always consult
vehicle manual for correct lifting specifications. Always wear safety glasses
and ensure a safe work area. Serious injury or death could occur if safety
measures are not followed.
BRExhaust recommends professional installation for all products.
Technical Support: 1-800-631-7271
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>