BRExhaust 106-0026 Muffler Kit Instruction Manual

June 13, 2024
BRExhaust

BRExhaust 106-0026 Muffler Kit Instruction Manual
106-0026 Muffler Kit

INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTION

WARNING:

When working on, under, or around any vehicle exercise caution.
Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult vehicle manual for correct lifting specifications.
Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.

STEP 1:
(Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean existing flange with a wire brush to ensure proper sealing.
STEP 2:
Attach item 5 to existing isolators
STEP 3:
Connect item 2 to existing exhaust using item 1 (cut to fit)
STEP 4:
Using item 1 connect item 3 to item 2
STEP 4:
Using item 1 connect item 5 to item 4
STEP 5:
Using item 1 connect item 4 to item 3
STEP 6:
Attach clamp provided with item 5 to secure slip fit joint
STEP 7:
Ensure new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
STEP 8:
Tighten all clamps and bolts starting from rear of the vehicle. (DO
NOT EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)
BR Exhaust recommends professional installation for all products

CUT TO FIT INSTALLATION INSTRUCTIONS

DESIGN TABLE

DESIGN STYLE 1: CUT TO FIT INTERMEDIATE PIPE

DESIGN STYLE 2: CUT TO FIT INLET

DESIGN STYLE 3: CUT TO FIT TAIL PIPE


WARNING:

When working on, under, or around any vehicle exercise caution.
Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.

MATCH PURCHASED KIT’S CUT TO FIT DESIGN
TO GRAPHIC IN DESIGN TABLE

DESIGN STYLE 1

STEP 1:
Attach item 1 to existing exhaust
STEP 2:
Attach item 3 to existing isolators
STEP 3:
Cut item 2 4” longer than the distance between the installed parts, this will allow for a 2” overlap for each slip fit (cutting part too short will increase likelihood of leaks)

DESIGN STYLE 2

STEP 1:
Attach item 3 to existing isolators
STEP 2:
Attach item 2 to item 3
STEP 3:
Cut item 2 2” longer than the distance between item 2 and OEM part, this will allow for a 2” overlap (cutting part too short will increase likelihood of leaks)

DESIGN STYLE 3

STEP 1:
Attach item 1 to existing isolators
STEP 2:
Attach item 3 to existing isolators
BR Exhaust  recommends professional installation for all products

Technical Support: 1-800-631-7271

BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056 www.brexhaust.com

BRExhaust Logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals