BRExhaust 106-0011 Direct Fit Replacement Exhaust System Instruction Manual

BRExhaust 106-0011 Direct Fit Replacement Exhaust System Instruction

Manual

INSTALLATION

WARNING:

When working on, under, or around any vehicle exercise caution.
Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult vehicle manual for correct lifting specifications.
Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.

PART NO. 106-0011

TEP 1:

(Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean existing flange with a wire brush to ensure proper sealing.

STEP 2:

Attach item 4 to existing isolators

STEP 3:

Connect item 1 to existing exhaust (short wheelbase—cut to fit)

STEP 4:

Using item 2 connect item 3 to item 1

STEP 5:

Using item 2 connect item 3 to item 4

STEP 6:

**** Attach clamp provided with item 4 to secure slip fit joint

STEP 7:

Ensure new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.

STEP 8:

Tighten all clamps and bolts starting from rear of the vehicle. (DO NOT EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY

BRExhaust recommends professional installation for all products

Technical Support: 1-800-631-7271

www.brexhaust.com

Read More About This Manual & Download PDF:

References

• MagnaFlow Exhaust, Mufflers & Cat Converters - Quality. Power. Sound.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>