BRExhaust 106-0051 Jeep Wrangler Direct Fit Replacement Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 106-0051 Jeep Wrangler Direct Fit Replacement Instruction
Manual
INSTALLATION
WARNING:
When working on, under, or around any vehicle exercise caution.
Please allow the vehicle’s exhaust system to cool before removal, as exhaust
temperatures may cause severe burns. If working without a lift, always consult
vehicle manual for correct lifting specifications.
Always wear safety glasses and ensure a safe work area. Serious injury or
death could occur if safety measures are not followed.
STEP 1:
(Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean existing flange with a wire brush to ensure proper sealing.
STEP 2:
Attach item 3 to existing exhaust (use item 2 and second clamp for 4.2L engine)
STEP 3:
Connect item 5 to existing isolators and item 3 with item 4
STEP 4:
Ensure new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
STEP 5:
Tighten all clamps starting from rear of the vehicle. (DO NOT
EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES.
RETIGHTEN IF NECESSARY)
BRExhaust recommends professional installation for all products
Technical Support: 1-800-631-7271
www.brexhaust.com
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>