BRExhaust 106-0280 Muffler Kit Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 106-0280 Muffler Kit Instruction Manual
INSTALLATION INSTRUCTIONS
WARNING:
When working on, under, or around any vehicle exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.
STEP 1:
(Carefully read all instructions before installation) Disconnect the vehicle’s
battery before removal of the OEM exhaust system. This will prevent electrical
accidents and will reset the computer if it applies to the vehicle. Remove
existing exhaust system from the vehicle. Only remove parts that will be
replaced. Clean existing flange with a wire brush to ensure proper sealing.
STEP 2:
Begin installation by installing items 1 and 2 to existing exhaust
STEP 2A:
Trim item 2 to fit other wheelbases
STEP 5:
Attach item 3 to existing isolators and connect to item 2 with item 1
STEP 5:
Attach item 4 to existing isolators and connect to item 3 with item 1
STEP 3:
Attach item 5 to existing isolators and connect to item 4 with item 1
STEP 7:
Attach clamp provided with item 5 to item 5
STEP 8:
Ensure new exhaust is not contacting any portion of the underbody of the
vehicle or drivetrain.
STEP 9:
Tighten all clamps and bolts starting from rear of the vehicle. (DO NOT
EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES.
RETIGHTEN IF NECESSARY)
BR Exhaust recommends professional installation for all products
Technical Support: 1-800-631-7271
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
www.brexhaust.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>