BRExhaust 106-0115 Direct Fit Replacement Exhaust System Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 106-0115 Direct Fit Replacement Exhaust System
Product Information
The product is an exhaust system, part number 106-0115, manufactured by BRExhaust. It is designed to replace the OEM (Original Equipment Manufacturer) exhaust system in a vehicle. The exhaust system is made up of various components, including clamps, bolts, isolators, and items numbered 1, 2, 3, and 4.
BRExhaust recommends professional installation for all their products to
ensure proper installation and performance. If you need technical support or
have any questions regarding the product, you can contact BRExhaust’s
Technical Support at 1-800-631-7271.
The company’s address is 1901 Corporate Ctr, Oceanside, CA 92056. More
information can be found on their website
at www.brexhaust.com.
Product Usage Instructions
- Carefully read all instructions before installation.
- Disconnect the vehicle’s battery before removing the OEM exhaust system to prevent electrical accidents and reset the computer if applicable.
- Remove the existing exhaust system from the vehicle, only removing the parts that will be replaced.
- Clean the existing flange with a wire brush to ensure proper sealing.
- Begin installation by installing items 1 and 2 to the existing exhaust.
- Attach item 4 to the existing isolators.
- Connect item 4 and 2 together with item 3.
- Ensure the new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
- Tighten all clamps and bolts starting from the rear of the vehicle. Do not exceed 30ft-lb when tightening the clamp. Check all clamps again after driving 50 miles and retighten if necessary.
It is important to exercise caution when working on, under, or around any vehicle. Allow the vehicle’s exhaust system to cool before removal to avoid severe burns from the high exhaust temperatures. If working without a lift, always consult the vehicle manual for correct lifting specifications. Safety glasses should always be worn, and a safe work area should be ensured to prevent serious injury or death.
INSTALLATION INSTRUCTIONS | PART NO. 106-0115
STEP 1
(Carefully read all instructions before installation) Disconnect the vehicle’s
battery before removal of the OEM exhaust system. This will prevent electrical
accidents and will reset the computer if it applies to the vehicle. Remove
existing exhaust system from the vehicle. Only remove parts that will be
replaced. Clean existing flange with a wire brush to ensure proper sealing.
STEP 2
Begin installation by installing items 1 and 2 to existing exhaust
STEP 3
Attach item 4 to existing isolators
STEP 4
Connect item 4 and 2 together with item 3
STEP 5
Ensure new exhaust is not contacting any portion of the underbody of the
vehicle or drivetrain.
STEP 6
Tighten all clamps and bolts starting from rear of the vehicle. (DO NOT EXCEED
30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN
IF NECESSARY)
WARNING
When working on, under, or around any vehicle exercise caution. Please allow
the vehicle’s exhaust system to cool before removal, as exhaust temperatures
may cause severe burns. If working without a lift, always consult vehicle
manual for correct lifting specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death could occur if safety
measures are not followed.
BRExhaust recommends professional installation for all products
- Technical Support : 1-800-631-7271
- BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
- www.brexhaust.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>