BRExhaust 106-0028 157 Wheelbase Replacement Exhaust Kit Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
INSTALLATION INSTRUCTIONS
PART NO. 106-0028
106-0028 157 Wheelbase Replacement Exhaust Kit
2: 157” Wheelbase
3: 139” Wheelbase
6: 135” Wheelbase
WARNING:
When working on, under, or around any vehicle exercise caution. Please allow
the vehicle’s exhaust system to cool before removal, as exhaust temperatures
may cause severe burns. If working without a lift, always consult vehicle
manual for correct lifting specifications.
Always wear safety glasses and ensure a safe work area. Serious injury or
death could occur if safety measures are not followed.
STEP 1:
(Carefully read all instructions before installation) Disconnect the vehicle’s
battery before removal of the OEM exhaust system. This will prevent electrical
accidents and will reset the computer if it applies to the vehicle. Remove
existing exhaust system from the
vehicle. Only remove parts that will be replaced. Clean existing flange with a
wire brush to ensure proper sealing.
STEP 2:
Attach item 5 to existing isolators and install clamp(s) provided with item 5
STEP 3:
Attach extension pipe (item 2, 3 or 6) to existing exhaust
STEP 4:
Place item 4 between extension pipe and item 5
STEP 5:
Place item 1 between items 4 and 5
STEP 6:
Place item 1 between extension pipe and item 4
STEP 7:
Place item 1 between extension pipe and currently installed exhaust
STEP 8:
Ensure new exhaust is not contacting any portion of the underbody of the
vehicle or drivetrain.
STEP 9:
Tighten all clamps starting from rear of the vehicle. (DO NOT EXCEED 30FT-LB
WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF
NECESSARY)
BRExhaust recommends professional installation for all products
Technical Support: 1-800-631-7271
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
www.brexhaust.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>