BRExhaust 106-0018 Jeep Grand Cherokee Direct Fit Replacement Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
A MF MAGNAFLOW GROUP COMPANY
INSTALLATION INSTRUCTIONS
PART NO. 106-0018
106-0018 Jeep Grand Cherokee Direct Fit Replacement
WARNING:
When working on, under, or around any vehicle exercise caution. Please allow
the vehicle’s exhaust system to cool before removal, as exhaust temperatures
may cause severe burns. If working without a lift, always consult vehicle
manual for correct lifting specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death could occur if safety
measures are not followed.
STEP 1:
(Carefully read all instructions before installation) Disconnect the vehicle’s
battery before removal of the OEM exhaust system. This will prevent electrical
accidents and will reset the computer if it applies to the vehicle. Remove
existing exhaust system from the vehicle. Only remove parts that will be
replaced. Clean existing flange with a wire brush to ensure proper sealing.
STEP 2:
Begin installation by sliding item 4 together and placing into isolators.
Place clamp attached to item 4 on slip fit joint.
STEP 3:
Attach item 2 to currently installed exhaust and item 3
STEP 3A:
Use item 3 and 5 for 4.7L engine
STEP 4:
Place item 3 between item 2 and 4.
STEP 5:
Install item 1 on the inlet of item 2
STEP 6:
Ensure new exhaust is not contacting any portion of the underbody of the
vehicle or drivetrain.
STEP 7:
Tighten all clamps starting from rear of the vehicle. (DO NOT EXCEED 30FT-LB
WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF
NECESSARY)
BRExhaust recommends professional installation for all products
Technical Support: 1-800-631-7271
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
www.brexhaust.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>