BRExhaust 106-0226 Replacement Exhaust System Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
INSTALLATION INSTRUCTIONS
PART NO. 106-0226
106-0226 Replacement Exhaust System
STEP 1:
(Carefully read all instructions before installation) Disconnect the vehicle’s
battery before removal of the OEM exhaust system. This will prevent electrical
accidents and will reset the computer if it applies to the vehicle. Remove
existing exhaust system from the vehicle. Only remove parts that will be
replaced. Clean existing flange with a wire brush to ensure proper sealing.
STEP 2:
Attach item 5 to existing isolators
STEP 3:
Connect item 3 (127.8” WB) or item 8 (110” WB) to existing exhaust with item 1
and item 2
STEP 4:
Connect item 3 or item 8 to item 5 with item 4
STEP 5:
Attach item 7 to existing isolator and connect to item 5 using item 6
STEP 6:
Ensure new exhaust is not contacting any portion of the underbody of the
vehicle or drivetrain.
STEP 7:
Tighten all clamps and bolts starting from rear of the vehicle. (DO NOT EXCEED
30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN
IF NECESSARY)
WARNING:
When working on, under, or around any vehicle exercise caution.
Please allow the vehicle’s exhaust system to cool before removal, as exhaust
temperatures may cause severe burns. If working without a lift, always consult
vehicle manual for correct lifting specifications.
Always wear safety glasses and ensure a safe work area. Serious injury or
death could occur if safety measures are not followed.
BR Exhaust recommends professional installation for all products
Technical Support: 1-800-631-7271
BR Exhaust — 1901 Corporate Ctr, Oceanside, CA 92056
www.brexhaust.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>