BRExhaust 106-0673 Direct Fit Replacement Exhaust System Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 106-0673 Direct Fit Replacement Exhaust System
Product Information
The product is an exhaust system, part number 106-0673, manufactured by
BRExhaust. It is designed to replace the OEM (Original Equipment Manufacturer)
exhaust system in a vehicle. The exhaust system includes a tailpipe, muffler,
slip fit joint, clamps, and isolators.
BRExhaust recommends professional installation for all their products. For
technical support, you can contact them at
1-800-631-7271. The company is located
at 1901 Corporate Ctr, Oceanside, CA 92056. More information can be found on
their website: www.brexhaust.com.
Product Usage Instructions
- Carefully read all instructions before installation.
- Disconnect the vehicle’s battery before removing the OEM exhaust system to prevent electrical accidents and reset the computer if applicable.
- Remove the existing exhaust system from the vehicle, only removing the parts that will be replaced.
- Clean the existing flange with a wire brush to ensure proper sealing.
- Attach the tailpipe to the existing isolators.
- Connect the muffler to the existing exhaust using item 1.
- Connect item 2 slip fit joint with the provided clamp.
- Ensure that the new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
- Tighten all clamps and bolts starting from the rear of the vehicle. Do not exceed 30 ft-lb when tightening clamps. Check all clamps after driving 50 miles and retighten if necessary.
WARNING : When working on, under, or around any vehicle, exercise caution. Allow the vehicle’s exhaust system to cool before removal to avoid severe burns from exhaust temperatures. If working without a lift, always consult the vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Failure to follow safety measures can result in serious injury or death.
INSTALLATION INSTRUCTIONS
- STEP 1: (Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove the existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean the existing flange with a wire brush to ensure proper sealing.
- STEP 2: Attach tailpipe to existing isolators
- STEP 3: Connect muffler to existing exhaust with item 1
- STEP 4: Connect item 2 slip-fit joint with the clamp provided
- STEP 5: Ensure the new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
- STEP 6: Tighten all clamps and bolts starting from the rear of the vehicle. (DO NOT EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)
WARNING:
When working on, under, or around any vehicle exercise caution. Please allow
the vehicle’s exhaust system to cool before removal, as exhaust temperatures
may cause severe burns. If working without a lift, always consult the vehicle
manual for correct lifting specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death could occur if safety
measures are not followed
BRExhaust recommends professional installation for all products
Technical Support: 1-800-631-7271
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
www.brexhaust.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>