BRExhaust 106-0120 Direct-Fit Exhaust System Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 106-0120 Direct-Fit Exhaust System
Product Information
This product is an exhaust system designed for vehicles. It is manufactured by BRExhaust and comes with part number 106-0120. The exhaust system is designed to replace the OEM (Original Equipment Manufacturer) exhaust system of the vehicle.
Product Usage Instructions
- Carefully read all instructions before installation.
- Disconnect the vehicle’s battery before removing the OEM exhaust system to prevent electrical accidents and reset the computer if applicable.
- Remove the existing exhaust system from the vehicle, only removing the parts that will be replaced.
- Clean the existing flange with a wire brush to ensure proper sealing.
- Begin installation by installing items 1 and 2 to the existing exhaust.
- Connect items 1 and 3 to the existing exhaust.
- Attach item 5 to the existing isolators and connect it to items 2 and 3 with item 4.
- Connect items 5 and 7 together using item 6.
- Ensure that the new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
- Tighten all clamps and bolts starting from the rear of the vehicle. Do not exceed 30ft-lb when tightening clamps. Check all clamps after driving for 50 miles and retighten if necessary.
WARNING
When working on, under, or around any vehicle, exercise caution.
Allow the vehicle’s exhaust system to cool before removal to avoid severe
burns from exhaust temperatures. If working without a lift, always consult the
vehicle manual for correct lifting specifications. Always wear safety glasses
and ensure a safe work area. Serious injury or death could occur if safety
measures are not followed.
BRExhaust recommends professional installation for all products.
For technical support, contact 1-800-631-7271.
BRExhaust address: 1901 Corporate Ctr, Oceanside, CA 92056.
Visit the website www.brexhaust.com for more information.
INSTALLATION INSTRUCTIONS
PART NO. 106-0120
STEP 1: (Carefully read all instructions before installation) Disconnect
the vehicle’s battery before removal of the OEM exhaust system. This will
prevent electrical accidents and will reset the computer if it applies to the
vehicle. Remove the existing exhaust system from the vehicle. Only remove
parts that will be replaced. Clean the existing flange with a wire brush to
ensure proper sealing.
STEP 2: Begin installation by installing items 1 and 2 to the existing
exhaust
STEP 3: Connect items 1 and 3 to existing exhaust
STEP 4: Attach item 5 to existing isolators and connect to items 2 and 3
with item 4
STEP 5: Connect items 5 and 7 together with item 6
STEP 6: Ensure the new exhaust is not contacting any portion of the
underbody of the vehicle or drivetrain.
STEP 7: Tighten all clamps and bolts starting from the rear of the
vehicle. (DO NOT EXCEED 30FT-LB WHEN TIGHTENING THE CLAMP AND CHECK ALL CLAMPS
AFTER 50 MILES. RETIGHTEN IF NECESSARY)
WARNING
When working on, under, or around any vehicle exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult the vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.
BRExhaust recommends professional installation for all products.
Technical Support
- 1-800-631-7271
- BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
- www.brexhaust.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>