BRExhaust 106-0113 Direct-Fit Exhaust System Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 106-0113 Direct-Fit Exhaust System
Product Information
- Product Name: BRExhaust
- Part Number: 106-0113
- Manufacturer: BRExhaust
Product Installation Instructions
- Disconnect the vehicle’s battery before removing the OEM exhaust system to prevent electrical accidents and reset the vehicle’s computer (if applicable).
- Remove the existing exhaust system from the vehicle, only removing the parts that will be replaced.
- Clean the existing flange with a wire brush to ensure proper sealing.
- Begin installation by installing items 1 and 2 to the existing exhaust.
- Attach item 4 to the existing isolators and connect it to item 2 with item 3.
- Attach the clamp provided with item 4 on the slip fit joint.
- Ensure the new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
- Tighten all clamps and bolts starting from the rear of the vehicle. Do not exceed 30ft-lb when tightening the clamp. Check all clamps after 50 miles and retighten if necessary.
Warning
When working on, under, or around any vehicle, exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult the vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.
Manufacturer’s Recommendation
- BRExhaust recommends professional installation for all products.
Technical Support
- For technical support, please contact BRExhaust at 1-800-631-7271.
INSTALLATION INSTRUCTIONS
- STEP 1: (Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean existing flange with a wire brush to ensure proper sealing.
- STEP 2: Begin installation by installing items 1 and 2 to existing exhaust
- STEP 3: Attach item 4 to existing isolators and connect to item 2 with item 3
- STEP 4: Attach clamp provided with item 4 on slip fit joint
- STEP 5: Ensure new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
- STEP 6: Tighten all clamps and bolts starting from rear of the vehicle. (DO NOT EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)
WARNING: When working on, under, or around any vehicle exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.
WARNING: BRExhaust recommends professioal installation for all products
Contact
- Technical Support: 1-800-631-7271
- BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
- www.brexhaust.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>