BRExhaust 106-0104 Direct-Fit Exhaust Kit Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 106-0104 Direct-Fit Exhaust Kit
Product Information
The product is an exhaust system designed for a vehicle. It is manufactured by BRExhaust and its part number is 106-0104. The product includes various items that need to be attached to the existing exhaust system for installation.
Product Installation Instructions
-
(Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean existing flange with a wire brush to ensure proper sealing.
-
Attach item 3 to existing exhaust with item 1 and 2.
-
Attach item 6 to existing isolators and attach clamp provided
with item 6. -
Attach item 5 to item 3 and item 4.
-
Attach item 4 to item 5 and item 3.
-
Ensure new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
-
Tighten all clamps starting from the rear of the vehicle. (DO NOT EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)
WARNING: When working on, under, or around any vehicle exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed. BRExhaust recommends professional installation for all products.
INSTALLATION INSTRUCTIONS
- STEP 1: (Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean existing flange with a wire brush to ensure proper sealing.
- STEP 2: Attach item 3 to existing exhaust with item 1 and 2
- STEP 3: Attach item 6 to existing isolators and attach clamp provided with item 6
- STEP 4: Attach item 5 to item 3 and item 4
- STEP 5: Attach item 4 to item 5 and item 3
- STEP 5: Ensure new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
- STEP 6: Tighten all clamps starting from rear of the vehicle. (DO NOT EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)
WARNING: When working on, under, or around any vehicle exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.
WARNING: BRExhaust recommends professional installation for all products
Contact
- Technical Support: 1-800-631-7271
- BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
- www.brexhaust.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>