BRExhaust 106-0071 Direct-Fit Replacement Exhaust System Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 106-0071 Direct-Fit Replacement Exhaust System
Product Information
The product is an exhaust system designed for vehicles. It is manufactured by BRExhaust and its part number is 106-0071. The installation of this exhaust system requires disconnecting the vehicle’s battery and removing the existing OEM exhaust system. The product comes with various items including clamps, isolators, and slip-fit joints.
Product Usage Instructions
- Carefully read all instructions before installation.
- Disconnect the vehicle’s battery before removing the OEM exhaust system to prevent electrical accidents and reset the computer if applicable.
- Remove the existing exhaust system from the vehicle, only removing the parts that will be replaced.
- Clean the existing flange with a wire brush to ensure proper sealing.
- Attach item 2 to the existing exhaust and isolators using items 1 and 5.
- Attach item 4 to the existing isolators and item 2 using item 3.
- Connect the slip-fit joint on item 4 with the provided clamps.
- Ensure that the new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
- Tighten all clamps starting from the rear of the vehicle. Do not exceed 30 ft-lb when tightening the clamp. Check all clamps again after driving 50 miles and retighten if necessary.
- Always exercise caution when working on, under, or around any vehicle. Allow the vehicle’s exhaust system to cool before removal to avoid burns. If working without a lift, consult the vehicle manual for correct lifting specifications. Wear safety glasses and ensure a safe work area to prevent serious injury or death.
- Professional installation is recommended for all BRExhaust products.
Technical Support
- If you need technical support or have any questions, you can contact BRExhaust at 1-800-631-7271.
BRExhaust Contact Information
BRExhaust 1901 Corporate Ctr, Oceanside, CA 92056 Website: www.brexhaust.com
INSTALLATION INSTRUCTIONS
PART NO. 106-0071
STEP 1: (Carefully read all instructions before installation) Disconnect
the vehicle’s battery before removal of the OEM exhaust system. This will
prevent electrical accidents and will reset the computer if it applies to the
vehicle. Remove the existing exhaust system from the vehicle. Only remove
parts that will be replaced. Clean the existing flange with a wire brush to
ensure proper sealing.
STEP 2
Attach item 2 to existing exhaust and isolators with items 1 and 5
STEP 3
Attach item 4 to existing isolators and item 2 with item 3
STEP 4
Connect slip-fit joint on item 4 with clamps provided
STEP 5
Ensure new exhaust is not contacting any portion of the underbody of the
vehicle or drivetrain.
STEP 6
Tighten all clamps starting from the rear of the vehicle. (DO NOT EXCEED 30FT-
LB WHEN TIGHTENING THE CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF
NECESSARY).
WARNING
- When working on, under, or around any vehicle exercise caution.
- Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns.
- If working without a lift, always consult the vehicle manual for correct lifting specifications.
- Always wear safety glasses and ensure a safe work area.
- Serious injury or death could occur if safety measures are not followed.
BRExhaust recommends professional installation for all products.
Technical Support
- 1-800-631-7271
- BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
- www.brexhaust.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>