BRExhaust 106-0200 Exhaust System Kit Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
106-0200 Exhaust System Kit
Instruction Manual
106-0200 Exhaust System Kit
1. Crew and
Extended Cab
5. Regular Cab
WARNING:
When working on, under, or around any vehicle exercise caution.
Please allow the vehicle’s exhaust system to cool before removal, as exhaust
temperatures may cause severe burns. If working without a lift, always consult
vehicle manual for correct lifting specifications. Always wear safety glasses
and ensure a safe work area. Serious injuryto death could occur if safety
measures are not followed.
STEP 1:
(Carefully read all instructions before installation) Disconnect the
vehicle’s battery before removal of the OEM exhaust system. This will prevent
electrical accidents and will reset the computer if it applies to the vehicle.
Remove existing exhaust system from the vehicle. Only remove parts that will
be replaced. Clean existing flange with a wire brush to ensure proper sealing.
STEP 2: Attach item 4 to existing isolators
STEP 3: Connect item 1 to existing exhaust
STEP 3A : For regular cab, use item 5 instead of item 1
STEP 4: Connect item 3 to existing isolator and item 1 with item 2
STEP 5: Connect item 4 to item 3 with item 2
STEP 6: Attach clamp provided with item 4 to secure slip fit joint
STEP 7: Ensure new exhaust is not contacting any portion of the underbody
of the vehicle or drivetrain.
STEP 8: Tighten all clamps and bolts starting from rear of the vehicle.
(DO NOT EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50
MILES. RETIGHTEN IF NECESSARY)
BRExhaust recommends professional installation for all products
Technical Support:
1-800-631-7271
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
www.brexhaust.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>