BRExhaust 106-0576 Kits Exhaust Pipe Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
106-0576 Kits Exhaust Pipe
Instruction Manual
106-0576 Kits Exhaust Pipe
WARNING:
When working on, under, or around any vehicle exercise caution.
Please allow the vehicle’s exhaust system to cool before removal, as exhaust
temperatures may cause severe burns. If working without a lift, always consult
vehicle manual for correct lifting specifications. Always wear safety glasses
and ensure a safe work area. Serious injury or death could occur if safety
measures are not followed.
STEP 1:
(Carefully read all instructions before installation) Disconnect the vehicle’s
battery before removal of the OEM exhaust system. This will prevent electrical
accidents and will reset the computer if it applies to the vehicle. Remove
existing exhaust system from the vehicle. Only remove parts that will be
replaced. Clean existing flange with a wire brush to ensure proper sealing.
STEP 2: Attach item 2 to existing exhaust with item 1
STEP 3: Connect item 3 to existing isolator and to item 2 with item 1
STEP 4: Connect item 5 to item 3 with item 4
STEP 5: Connect slip fit joint on item 5 with clamp provided
STEP 6: Ensure new exhaust is not contacting any portion of the underbody
of the vehicle or drivetrain.
STEP 7: Tighten all clamps starting from rear of the vehicle. (DO NOT
EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES.
RETIGHTEN IF NECESSARY)
BRExhaust recommends professional installation for all products
Technical Support:
1-800-631-7271
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
www.brexhaust.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>