BRExhaust 106-0525 Kits Exhaust Pipe Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
106-0525 Kits Exhaust Pipe
Instruction Manual
106-0525 Kits Exhaust Pipe
WARNING:
When working on, under, or around any vehicle exercise caution. Please allow
the vehicle’s exhaust system to cool before removal, as exhaust temperatures
may cause severe burns. If working without a lift, always consult vehicle
manual for correct lifting specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death could occur if safety
measures are not followed.
STEP 1:
(Carefully read all instructions before installation) Disconnect the
vehicle’s battery before removal of the OEM exhaust system. This will prevent
electrical accidents and will reset the computer if it applies to the vehicle.
Remove existing exhaust system from the vehicle. Only remove parts that will
be replaced. Clean existing flange with a wire brush to ensure proper sealing.
STEP 2: Attach item 2 to existing exhaust with item 1
STEP 2: Attach item 3 to existing isolator and item 2
STEP 3: Connect item 4 to existing isolators and item 2 with item 1
STEP 4: Connect item 5 to existing isolators and item 4 with item 1
STEP 5: Connect slip fit joint on item 5 with clamp provided
STEP 6: Ensure new exhaust is not contacting any portion of the underbody
of the vehicle or drivetrain.
STEP 7: Tighten all clamps starting from rear of the vehicle. (DO NOT
EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES.
RETIGHTEN IF NECESSARY)
BRExhaust recommends professional installation for all products
Technical Support:
1-800-631-7271
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
www.brexhaust.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>