BRExhaust 106-0462 Kits Exhaust Pipe Instruction Manual

June 13, 2024
BRExhaust

BRExhaust 106-0462 Kits Exhaust Pipe Instruction Manual
Kits Exhaust Pipe

INSTALLATION INSTRUCTIONS

Kits Exhaust Pipe

WARNING:

When working on, under, or around any vehicle exercise caution.
Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.

STEP 1:
(Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean existing flange with a wire brush to ensure proper sealing.
STEP 2:
Attach item 5 to existing isolators
STEP 3:
Connect item 2 to existing exhaust with item 1
STEP 4:
Connect item 4 to existing isolators
STEP 5:
Connect item 2 to item 4 with item 3
STEP 6:
Connect item 4 to item 5 with item 3
STEP 7:
Use clamp provided with item 5 to secure slip fit
STEP 8:
Ensure new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
STEP 9:
Tighten all clamps and bolts starting from rear of the vehicle. (DO
NOT EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)
BRE exhaust  recommends professional installation for all products

Technical Support: 1-800-631-7271

BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056

www.brexhaust.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals