n-FAB HPF1981CC-TX Podium LG Steps Instruction Manual
- June 13, 2024
- n-FAB
Table of Contents
n-FAB HPF1981CC-TX Podium LG Steps
Product Information
- Product: Podium Hoop Step
- Application: Ford Ranger
- Part Number: HPF1981CC-TX
- I-Sheet Part Number: INST-00111
Hardware Description:
- HWKT-04239X
- QTY.
- FHLB 04240X – M10x25mm Hex Flanged Bolt (12 pieces)
- M10 Hex Nut (12 pieces)
- M10X25mm Carriage Bolt (12 pieces)
Parts Included:
- Driver Side Step – 1 piece
- Passenger Side Step – 1 piece
- Mounting Bracket – 6 pieces
Product Usage Instructions
- Identify the driver side step.
- Using the supplied M10 carriage bolt and nut, install the (x6) mounting brackets to each attachment point on the main tube. Leave them loose for now. Note that the brackets should attach to the backside of the mounting flange with the threaded end of the carriage bolt facing towards the rear of the step.
- Remove any factory running boards or hardware and discard.
- Clean and tap the three factory threaded mounting locations.
- Carefully place the step into place and loosely fasten it using the supplied M10X25mm hardware.
- Tighten the three lower bolts first, then tighten the three upper bolts.
- After final adjustment, tighten all M10 carriage bolts on the main tube.
- Repeat steps 2-7 with the passenger side.
For any further assistance or inquiries, please contact:
- 12302 Shiloh Church Rd. Houston TX 77066
- Phone: 281-880-6322
- Fax: 281-880-6325
I-SHEET PART NUMBER: INST-00111
PART NUMBER: HPF1981CC-TX
PRODUCT: PODIUM HOOP STEP
APPLICATION: FORD RANGER
HARDWARE DESCRIPTION
HARDWARE DESCRIPTION
HWKT-04239X
| QTY.
---|---
FHLB 04240X| M10x25mm HEX FLANGED BOLT|
12
M10 hex nut| 12
M10X25mm Carriage bolt| 12
PARTS INCLUDED
PARTS INCLUDED | QTY |
---|---|
DRIVER SIDE STEP | 1 |
PASSENGER SIDE STEP | 1 |
MOUNTING BRACKET | 6 |
DO NOT USE IMPACT TOOLS
INSTRUCTION
STEP 1: Identify driver side step.
Step 2 Using the supplied M10 carriage bolt and nut, install the (x6) mounting brackets to each attachment point on the main tube and leave loose for now.
NOTE: The brackets will attach to the backside of the mounting flange with the threaded end of the carriage bolt facing towards the REAR of the step.
STEP 3: Remove any factory running boards or hardware and discard.
STEP 4: Clean/tap the three factory threaded mounting locations.
STEP 5: Carefully place step into place and loosely fasten using the supplied M10X25mm hardware.
Step 6: Next, tighten the three lower bolts first following with the three upper bolts.
Step 7: After finial adjustment, tighten all M10 carriage bolts on the main tube.
Step 8: Repeat steps 2-7 with passenger side.
12302 Shiloh Church Rd. Houston TX 77066 Phone 281-880-6322 – Fax 281-880-6325
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>