BRExhaust 106-0762 Direct Fit Replacement Exhaust System Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 106-0762 Direct Fit Replacement Exhaust System
INSTALLATION INSTRUCTIONS
WARNING:
When working on, under, or around any vehicle exercise caution.
Please allow the vehicle’s exhaust system to cool before removal, as exhaust
temperatures may cause severe burns. If working without a lift, always consult
vehicle manual for correct lifting specifications. Always wear safety glasses
and ensure a safe work area. Serious injury or death could occur if safety
measures are not followed.
STEP 1:
(Carefully read all instructions before installation) Disconnect the vehicle’s
battery before removal of the OEM exhaust system. This will prevent electrical
accidents and will reset the computer if it applies to the vehicle. Remove
existing exhaust system from the vehicle. Only remove parts that will be
replaced. Clean existing flange with a wire brush to ensure proper sealing.
STEP 2:
Attach [2] Resonator Assembly to existing exhaust with supplied [1] Hardware
and Gasket.
STEP 3:
Attach [4] Front Extension Pipe to [2] Resonator Assembly with supplied [3]
Clamp.
STEP 4:
Attach [6] Rear Extension Pipe to [4] Front Extension Pipe with supplied [5]
Clamp.
STEP 5:
Attach [8] Muffler Tail Pipe Assembly to [6] Rear Extension Pipe and existing
isolator with supplied [7] Clamp.
STEP 6:
Attach [10] Tail Pipe Assembly to [8] Muffler Tail Pipe Assembly and existing
isolator with supplied [9] Clamp.
STEP 7:
Ensure new exhaust is not contacting any portion of the underbody of the
vehicle or drivetrain.
STEP 8:
Tighten all clamps starting from rear of the vehicle. (DO NOT EXCEED 30FT-LB
WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF
NECESSARY)
BRExhaust recommends professional
installation for all products
Customer Support
Technical Support: 1-800-631-7271
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
www.brexhaust.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>