BRExhaust 106-0787 Direct-Fit Replacement Exhaust System Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 106-0787 Direct-Fit Replacement Exhaust System Instruction Manual
INSTALLATION INSTRUCTIONS
STEP 1:
(Carefully read all instructions before installation) Disconnect thevehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean existing flange with a wire brush to ensure proper sealing.
STEP 2:
Attach [3] Inlet Pipe Assembly to existing exhaust and isolator with supplied [1] Hardware and [2] Hanger Clamp.
STEP 3:
Attach [5] Muffler Assembly to [3] Inlet Pipe Assembly with supplied [4] Clamp.
STEP 4:
Attach [7] Over Axle Pipe Assembly to [5] Muffler Assembly and existing isolators with supplied [6] Clamp.
STEP 5:
Attach [9] Tail Pipe Assembly to [7] Over Axle Pipe Assembly and existing isolator with supplied [8] Clamp.
STEP 6:
Ensure new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
STEP 7:
Tighten all clamps starting from rear of the vehicle. (DO NOT EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)
WARNING
When working on, under, or around any vehicle exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.
Exhaust recommends professional installation for all products
Technical Support: 1-800-631-7271
www.brexhaust.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>