BRExhaust 106-0809 Direct Fit Exhaust System Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 106-0809 Direct Fit Exhaust System
Product Information
- Product Name: Exhaust System
- Part Number: 106-0809
- Manufacturer: BRExhaust
- Manufacturer Address: 1901 Corporate Ctr, Oceanside, CA 92056
- Website: www.brexhaust.com
- Technical Support: 1-800-631-7271
- Installation Instructions: Part No. 106-0809
- Revision Number: 000
- Date: 5/22/2023
Product Usage Instructions
- Carefully read all instructions before installation.
- Disconnect the vehicle’s battery before removing the OEM exhaust system to prevent electrical accidents and reset the vehicle’s computer if applicable.
- Remove the existing exhaust system from the vehicle, only removing the parts that will be replaced.
- Clean the existing flange with a wire brush to ensure proper sealing.
- Attach the Resonator Assembly (part [2]) to the existing exhaust using the supplied Clamp (part [1]).
- Attach the Mid Pipe (part [4]) to the Resonator Assembly (part [2]) using the supplied Clamp (part [3]).
- Attach the Muffler Assembly (part [6]) to the Mid Pipe (part [4]) and the existing isolator using the supplied Clamp (part [5]).
- Ensure that the new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
- Tighten all clamps, starting from the rear of the vehicle. Do not exceed 30 ft-lb when tightening the clamp. Check all clamps after driving 50 miles and retighten if necessary.
WARNING: When working on, under, or around any vehicle, exercise caution.
Allow the vehicle’s exhaust system to cool before removal to prevent burns
from exhaust temperatures. If working without a lift, always consult the
vehicle manual for correct lifting specifications. Always wear safety glasses
and ensure a safe work area. Failure to follow safety measures could result in
serious injury or death.
Note : BRExhaust recommends professional installation for all
products.
INSTALLATION INSTRUCTIONS
-
STEP 1: (Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean existing flange with a wire brush to ensure proper sealing.
-
STEP 2:
Attach [2] Resonator Assembly to existing exhaust with supplied [1] Clamp. -
STEP 3:
Attach [4] Mid Pipe to [2] Resonator Assembly with supplied [3] Clamp. -
STEP 4:
Attach [6] Muffler Assembly to [4] Mid Pipe and existing isolator with supplied [5] Clamp. -
STEP 5:
Ensure new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain. -
STEP 6:
Tighten all clamps starting from rear of the vehicle. (DO NOT EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)
WARNING
When working on, under, or around any vehicle exercise caution. Please allow
the vehicle’s exhaust system to cool before removal, as exhaust temperatures
may cause severe burns. If working without a lift, always consult vehicle
manual for correct lifting specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death could occur if safety
measures are not followed
BRExhaust recommends professional installation for all products
Technical Support : 1-800-631-7271
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
www.brexhaust.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>