n-FAB GFG15CC-TX Growler Running Board User Guide

June 13, 2024
n-FAB

n-FAB GFG15CC-TX Growler Running Board User Guide

HARDWARE DESCRIPTION QTY.

HWKT-00211X
CLIP-00643| M8-1.25 X 20MM BARREL U-NUT CLIP| 16
HHCS-00647| M8-1.25 X 25MM CLASS 8.8 HEX CAPSCREW| 16
FLHB-00688| 3/8″-16 X 1″ GRADE 5 HEX SERRATEDFLANGE BOLT| 16
HXNT-00736| M8 FENDER WASHER| 8
FDRW-00743| M8 FLAT WASHER| 8
PARTS INCLUDED| QTY
---|---
Running Boards| 2
Rocker Panel mounting Brackets| 8
Threaded clamp plates| 8


Step 1: Locate the rubber body plugs on the underside of the body. There will be four sections of two plugs each. One near the top of the body and one near the bottom.

Step 2: Insert one 8mm x 1 ¼’ threaded clip into each mounting hole by sliding the clip from the large hole and lining up the threaded part with the smaller hole. Make sure the flat side of the clip faces toward the outside of the body.

Step 3: Next, install (x4) mounting brackets using the supplied M8 x 30mm flanged hex bolts and leave hand tight for now.
NOTE: Use large washer with top fastener and small washer with lower

Step 4: Set running board along the top of all three brackets and center along the cab.

Step 5: Insert the supplied threaded brackets (x4) inside the running board lip over the top of each bracket.
Step 6: With the supplied 3/8” x 1” hex bolts, secure each mounting location and leave loose.
Step 7: After final adjustment, tighten all running board threaded mounts.
Step 8: Next, adjust frame brackets so the running board is level with body of the vehicle and tighten all factory-mounting locations.
Step 9: Repeat steps 1-8 for opposite side.

I-SHEET: INST-00023
PART NUMBER: GFG15CC-TX
PRODUCT: Growler Running Board
APPLICATION: 15-23 COLORADO/CANYON

12302 Shiloh Church Rd. Houston TX 77066 Phone 281-880-6322 – Fax 281-880-6325
REVISION – – © 2018 N-FAB, INC. REVISION DATE 11/08/19

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals