RYNOSKIN RSSS-JK0201 DS7 II Python Side Steps Installation Guide
- June 13, 2024
- RYNOSKIN
Table of Contents
RYNOSKIN RSSS-JK0201 DS7 II Python Side Steps
Torque & Tools
BEFORE INSTALLATION
REMOVE CONTENTS FROM THE BOX. VERIFY ALL PARTS ARE PRESENT DEPENDING ON THE PARTS LIST. READ INSTRUCTIONS CAREFULLY. CUTTING MAY BE REQUIRED. ASSISTANCE IS RECOMMENDED.
Part List
PLEASE NOTE THAT THE FOLLOWING PICTURES ARE BASED ON THE PASSENGER-SIDE INSTALLATION
STEP 1
Start installation toward the front of the Passenger/Right side of the
vehicle, Locate the front, center, and rear mounting locations (Fig 1).
STEP 2
Determine if the vehicle has an open floor panel or a threaded hole in the
floor panel
-
Vehicles with open mounting location:
a. Insert (1) 10mm Nut Plate into the large square opening in the floor panel. Line up the threaded nut with the hole in between the pair of holes on the pinch weld, (Fig 2).
b. Select the Passenger/Right Front Mounting Bracket. NOTE: There is a small notch at the Bottom of the Center Brackets and the notch of Rear Brackets is at the Top. Please identify the Front, Center, and Rear Brackets according to the Part List.
c. Attach the Bracket to the Nut Plate with (1) 10mm x 35mm Hex Bolt, (1) 10mm Lock Washer, and (1) 10mm x 34mm Flat Washer, (Fig 3). Do not tighten the hardware.
-
Vehicles with factory threaded holes in floor panels:
a. Select the Passenger/Right Front Mounting Bracket. Attach the Bracket to the front mounting location (Fig 4) with (1) 8mm Hex Bolt, (1) 8mm Lock Washer, and (1) 8mm Flat Washer, (Fig 5). Do not tighten the hardware.
STEP 4
Attach the Support Bracket to the Mounting Bracket with (1) 10mm x 30mm Hex
Bolt, (2) 10mm x 20mm Flat Washers, and (1) 10mm Nylon Lock Nut, (Fig 7). Do
not tighten the hardware.
STEP 5
Repeat Steps 2 – 4 to attach the Passenger/Right Center and Rear Mounting
Brackets and Support Brackets to the center and rear locations, (Figs 8- 9).
NOTE: There is a small notch at the Bottom of the Center Brackets and the
notch of Rear Brackets is at the Top. Please identify the Center and Rear
Brackets according to this, (Fig 10). Do not tighten the hardware.
STEP 6
Select the Passenger/Right Running Board.
NOTE: The Passenger/Right Running Board will have a “P” on the front.
Attach the Running Board to the Mounting Brackets with (6) 8mm Combo Bolts,
(Fig 11). IMPORTANT: Do not slide the Running Board on the Mounting Bracket
cradles, or damage to the finish may result. Do not tighten the hardware.
STEP 7
Level and adjust the Running Board and tighten all hardware.
STEP 8
Repeat Steps 1—7 to attach the Driver/Left Running Board.
STEP 9
Do periodic inspections of the installation to make sure that all hardware is
secure and tight.
Attention
To protect your investment, do not use any type of polish or wax that may
contain abrasives that could damage the finish.
Mild soap may be used also to clean the Running Boards.
www.rynoskinauto.com.
Customer Support:
service@rynoskinauto.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>