RYNOSKIN RS-JSS-122 Running Boards Owner’s Manual
- June 13, 2024
- RYNOSKIN
Table of Contents
RYNOSKIN RS-JSS-122 Running Boards Owner’s Manual
RS-FSS-018 Stirrups
| |
---|---|---
60 120-min| Do not cut
Required| Drilling not required
Torque and tools
bra size| Tightening torque (ft-lbs)| Key required Allen key|
Required
---|---|---|---
6mm| 7-8.5| | 10mm| | 4mm
8mm| 18-20| 13mm| 5mm
10mm| 35-40| 16mm| 6mm
12mm| 60-70| 18mm| 8mm
BEFORE INSTALLATION
REMOVE THE CONTENTS OF THE BOX. VERIFY THAT ALL PARTS ARE PRESENT DEPENDING ON
THE PARTS LIST. READ THE INSTRUCTIONS CAREFULLY. THE BUMPER IS HEAVY,
ASSISTANCE IS RECOMMENDED TO AVOID POSSIBLE INJURIES OR DAMAGE TO THE
VEHICLE.Unmute
oaded: 19.20%Remaining Time –4:30
Part List
PLEASE NOTE THE FOLLOWING
PICTURES ARE BASED ON THE
PASSENGER SIDE INSTALLATION
STEP 1
Starting from under the right/passenger body panel, locate the front mounting
location and threaded holes in the body panel (Fig. 1).
Remove the plastic plugs covering the holes.
STEP 2
Select the right front/passenger mounting bracket. Secure the mounting bracket
to the front location with (2) 10mm hex bolts, (2) 10mm lock washers, and (2)
10mm flat washers (Fig. 2). Do not tighten the hardware.
STEP 3
Repeat steps 1 and 2 to attach the center and rear passenger/right mounting
brackets to the center and rear locations (Figs. 3-6).
NOTE: There is a larger notch on the back of the center supports and a smaller notch on the bottom of the rear supports. Do not tighten the hardware.
STEP 4
Select the right/passenger rocker step.
NOTE: The right/passenger rocker step will have an “18R” on the front.
Carefully place Rocker Step on the supports. Attach the swing step to the (3)
mounting brackets with (6) 8mm combination bolts (Fig. 7). Do not tighten the
hardware.
STEP 6
Level and adjust the tilt step and fully tighten all hardware.
STEP 7
Repeat steps 1 through 6 to connect the left rocker step/controller.
STEP 8
Perform periodic installation inspections to ensure all hardware is secure and
tight.
Attention
To protect your investment, do not use any type of polish or wax that may
contain abrasives that could damage the finish.
Mild soap can also be used to clean the running boards.
www.rynoskinauto.com
Rev. 2/9/23 (JH)
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>