RYNOSKIN RS-FTH-001 Trailer Hitch 2 Receiver Installation Guide
- June 1, 2024
- RYNOSKIN
Table of Contents
RYNOSKIN RS-FTH-001 Trailer Hitch 2 Receiver
Specifications
- Part No.: RS-FTH-001
- Fits: 2021-2024 FORD BRONCO
- Tools Required: Wrench/Socket Set
- Installation Time: 90-180 minutes (varies by individual)
FAQ
- Q: How long does it take to install the Trailer Hitch 2 Receiver on a FORD BRONCO?
- A: The installation time typically ranges from 90 to 180 minutes, but it may vary based on individual experience.
- Q: Are cutting and drilling required for installation?
- A: No, cutting and drilling are not required for installing the Trailer Hitch 2 Receiver on a FORD BRONCO.
Torque & Tools
TOOLS REQUIRED
- WRENCH/SOCKET SET
DO NOT OVER TORQUE. PLEASE FOLLOW THE TIGHTEN OPERATING LOAD STANDARD BELOW:
- 6mm BOLTS & NUTS: FROM 7 TO 8.5 FOOT POUND.
- 8mm BOLTS & NUTS: FROM 18 TO 20 FOOT POUND.
- 10mm BOLTS & NUTS: FROM 35 TO 40 FOOT POUND.
- 12mm BOLTS & NUTS: FROM 60 TO 70 FOOT POUND.
TO PROTECT YOUR INVESTMENT, DO NOT USE ANY TYPE OF POLISH OR WAX THAT MAY CONTAIN ABRASIVES THAT COULD DAMAGE THE FINISH. MILD SOAP MAY BE USED TO CLEAN THE PRODUCTS.
PARTS LIST
Product Overview
Installation Instructions
PROCEDURE:
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
- Locate the mounting holes in the frame cross member behind the rear bumper, (Figure 1).
- Carefully unwrap the Receiver Hitch. Line up the holes in the Hitch with the cross member.
- Attach the Hitch to the cross member with the included (4) 12mm x 110mm Hex Bolts, (8) 12mm Flat Washers and (4) 12mm Nylon Lock Nuts, (Figures 2 & 3). NOTE: Insert the Hex Bolts from the front of the cross member through the back. Leave hardware loose at this time.
- Select the 4-Pin Wire Harness Bracket, (Figure 2). Remove the Flat Washer and Lock Nut from the driver/left outer end of the Receiver Hitch. Slide the Harness Bracket over the end of the Hex Bolt, (Figures 2 & 4). Reuse the Flat Washer and Lock Nut to secure the Bracket to the Hitch.
- Center and adjust the Receiver Hitch and fully tighten all hardware.
- Attach the trailer harness to the Trailer Connection Tab, if installed, (Figure 5).
- Do periodic inspections of the installation to make sure that all hardware is secure and tight.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>