RYNOSKIN RS-FSS-018 Running Boards Owner’s Manual
- June 13, 2024
- RYNOSKIN
Table of Contents
Rocker Step
PART NO. RS-FSS-018
FITS: 2021-Up Ford Bronco 4 Door
RS-FSS-018 Running Boards
| |
---|---|---
60-120 min| Cutting Not
Required| Drilling Not
Required
Torque & Tools
Fastener Size| Tightening Torque (ft-lbs)| Wrench Required Allen
Wrench| Required
---|---|---|---
6mm| 7-8.5| | 10mm| | 4mm
8mm| 18-20| 13mm| 5mm
10mm| 35-40| 16mm| 6mm
12mm| 60-70| 18mm| 8mm
BEFORE INSTALLATION
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT DEPEND ON THE PARTS LIST. READ INSTRUCTIONS CAREFULLY. BUMPER IS HEAVY, ASSISTANCE IS HIGHLY RECOMMENDED TO AVOID POSSIBLE INJURY OR DAMAGE TO THE VEHICLE.
Part List
PLEASE NOTE THAT THE FOLLOWING
PICTURES ARE BASED ON THE
PASSENGER SIDE INSTALLATION
STEP 1
Starting from underneath the Passenger/Right body panel, locate the front
mounting location and the threaded holes in the body panel, (Fig 1).
Remove the plastic plugs covering the holes.
STEP 2
Select the Passenger/Right Front Mounting Bracket. Attach the Mounting Bracket
to the front location with (2) 10mm Hex Bolts, (2) 10mm Lock Washers and (2)
10mm Flat Washers, (Fig 2). Do not tighten hardware.
STEP 3
Repeat Steps 1-2 to attach Passenger/Right Center and Rear Mounting Brackets
to the center and rear locations, (Figs 3-6).
NOTE: There is a Bigger Notch on the rear of the Center Brackets and a
Smaller Notch on the bottom of the Rear Brackets. Do not tighten hardware.
STEP 4
Select the Passenger/Right Rocker Step.
NOTE: The Passenger/Right Rocker Step will have a “18R” on the front.
Carefully place Rocker Step on the brackets. Attach Rocker Step to the (3)
Mounting Brackets with (6) 8mm Combo Bolts, (Fig 7). Do not tighten hardware.
STEP 6
Level and adjust the Rocker Step and fully tighten all hardware.
STEP 7
Repeat Steps 1—6 to attach the Driver/Left Rocker Step.
STEP 8
Do periodic inspections to the installation to make sure that all hardware is
secure and tight.
Attention
To protect your investment, do not use any type of polish or wax that may
contain abrasives that could damage the finish.
Mild soap may be used also to clean the Running Boards.
www.rynoskinauto.com
Rev. 2/9/23 (JH)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>