RYNOSKIN RSSS-FB2D-57 Running Boards Side Steps Owner’s Manual

June 13, 2024
RYNOSKIN

PYTHON SIDE STEP
PART NO. RSSS-FB2D-57
FITS: 2021-Up Ford Bronco 2 Door

| 90-180 min
---|---
| Cutting Not Required
| Drilling Not Required

Torque & Tools

Fastener
Size| | Tightening Torque (ft-lbs)

Wrench Required

| Allen Wrench
Required
---|---|---|---
▢  6mm| ▢ 7-8.5| | ▢ 10mm| | L 4mm
■ 8mm| ■ 18-20| ■ 13mm| ▢ 5mm
■ 10mm| ■ 35-40| ■ 16mm| ▢ 6mm
▢ 12mm| ▢ 60-70| ▢ 18mm| ▢ 8mm

BEFORE INSTALLATION

REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT
DEPEND ON THE PARTS LIST. READ INSTRUCTIONS CAREFULLY. CUTTING
MAY BE REQUIRED. ASSISTANCE IS RECOMMENDED.

Part List

RYNOSKIN RSSS FB2D 57 Running Boards Side Steps -

RYNOSKIN RSSS FB2D 57 Running Boards Side Steps - fig1

PLEASE NOTE THAT THE FOLLOWING
PICTURES ARE BASED ON THE
PASSENGER SIDE INSTALLATION
STEP 1
Starting from underneath the Passenger/Right body panel, locate the front mounting location and the threaded holes in the body panel, (Fig 1). Remove the plastic plugs covering the holes.

(Fig 1) Passenger/Right front mounting location
STEP 2
Select the Passenger/Right Front Mounting Bracket. Attach the Mounting Bracket to the front location with (2) 10mm Hex Bolts, (2) 10mm Lock Washers and (2) 10mm Flat Washers, (Fig 2). Do not tighten hardware.

(Fig 2) Attach the Passenger/Right Front Mounting Bracket to the front location
STEP 3
Repeat Steps 1-2 to attach (1) Passenger/Right Rear Mounting Brackets to the rear locations, (Figs 3-4). Do not tighten hardware.

(Fig 3) Passenger/Right rear mounting location

(Fig 4) Attach (1) Passenger/Right Rear Mounting Bracket to the rear location.
STEP 4
Select the Passenger/Right Running Board.
NOTE: The Passenger/Right Running Board will have a “57-P” on the front. Carefully place Running Board on the brackets. Attach Running Board to the (3) Mounting Brackets with (6) 8mm Combo Bolts, (Fig 5). Do not tighten hardware.

(Fig 5) Attach the Passenger/Right Running Board to the Mounting Brackets
STEP 5
Level and adjust the Running Board and fully tighten all hardware.
STEP 6
Repeat Steps 1—5 to attach the Driver/Left Running Board.
STEP 7
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
Attention
To protect your investment, do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap may be used also to clean the Running Boards.

www.rynoskinauto.com
Customer Support: service@rynoskinauto.com
6/2/23 (JH)

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals