duradecor DD-PP-5HDC6906 Polished Pro 5.75-Inch W Ashen Greige Rigid Core Click Lock Luxury Vinyl Plank Flooring Instruction Manual
- June 4, 2024
- duradecor
Table of Contents
duradecor DD-PP-5HDC6906 Polished Pro 5.75-Inch W Ashen Greige Rigid Core
Click Lock Luxury Vinyl Plank Flooring Instruction Manual
1. Precautions
Remove all metal objects before conducting maintenance and use caution tape
and/or “Wet Floor” signs to prohibit foot traffic until the floor is dry.
Do not use hydrocarbons, harsh disinfectants, cleaning agents, dyes, acetone
or other harsh chemicals – ensure all chemicals and materials that may come in
contact with flooring surface will not stain, mar or otherwise damage the
surface. Do not use abrasive cleaning pads, as these can damage the flooring.
The application of a floor-finish is not usually recommended and will change
the maintenance protocol. Allow area to dry completely before allowing foot
traffic.
2. Residential
Dust-mop or vacuum the floor to remove any dirt or debris. Damp-mop the floor as often as required using a flat microfiber mop or a spray mop. Use a pH neutral, filmfree and streak-free cleaner concentrate, available at home improvement stores, and make sure to change the pad as often as necessary. Steam cleaners with a micro-fiber head may also be used, providing the steaming head is never stationary, as prolonged, excessive heat can damage any vinyl floor covering.
3. Commercial
Dust-mop or vacuum the floor to remove any dirt or debris.
Mix a pH neutral, film-free and streak-free cleaner with clean, cool potable
water and damp-mop or spot clean the floor as often as necessary. Avoid wet
mopping, puddling or pooling cleaning liquid on the surface.
If flooring is heavily soiled or contaminated with gypsum dust, an auto-
scrubber or rotary machine (185 rpm or less) with pads or brushes that are
similar in grit to 3M 5100 Red Cleaning pads or a dual-bucket mop system must
be used to remove dirt and contaminants from the surface. Mix a pH neutral,
film-free and streak-free cleaner with clean, cool potable water at the
appropriate dilution level and, apply to the surface using a new or thoroughly
cleaned mop, except when using an auto-scrubber.
When using a rotary machine, ensure the surface stays wet while scrubbing to
prevent marring or dulling. When using a dual-bucket system, allow the
cleaning solution to dwell for 5-10 minutes before removing. Use a wet vacuum
or clean mop to remove the cleaning slurry, then rinse with clean, cool water
and use a wet vacuum or clean mop to remove any remaining liquid. Ensure that
all cleaning residues haves been removed (this may require additional
rinsing).
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>