BRExhaust 106-0525 Direct Fit Exhaust Kit Instruction Manual

BRExhaust 106-0525 Direct Fit Exhaust Kit

BILL OF MATERIALS

1. 167538
2. 169455
3. 169456
4. 168768
5. 168770

STEP 1
(Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove the existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean the existing flange with a wire brush to ensure proper sealing.

STEP 2
Attach item 2 to the existing exhaust with item 1

STEP 3
Attach item 3 to the existing isolator and item 2

STEP 4
Connect item 4 to existing isolators and item 2 with item 1

STEP 5
Connect item 5 to existing isolators and item 4 with item 1

STEP 6
Connect slip fit joint on item 5 with clamp provided

STEP 7
Ensure the new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.

STEP 8
Tighten all clamps starting from the rear of the vehicle. (DO NOT EXCEED 30FT- LB WHEN TIGHTENING THE CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY

WARNING

When working on, under, or around any vehicle exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult the vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed. BRExhaust recommends professional installation for all products

Technical Support: 1-800-631-7271
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056

References

• MagnaFlow Exhaust, Mufflers & Cat Converters - Quality. Power. Sound.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>