BRExhaust 1999-2004 Chrysler 300M 3.5L Direct Fit Exhaust Kit Installation Guide
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 1999-2004 Chrysler 300M 3.5L Direct Fit Exhaust Kit
BILL OF MATERIALS
- 169305
- 168402
- 167507
- 168404
- 168401
- 168405
- 168403
STEP 1:
(Carefully read all instructions before installation) Disconnect the vehicle’s
battery before removal of the OEM exhaust system. This will prevent electrical
accidents and will reset the computer if it applies to the vehicle. Remove the
existing exhaust system from the vehicle. Only remove parts that will be
replaced. Clean the existing flange with a wire brush to ensure proper
sealing.
STEP 2:
Attach item 2 to the existing exhaust with item 1
STEP 3:
Attach item 4 to the existing isolator and item 2 to item 3
STEP 4:
Attach item 5 to item 4 with item 3
STEP 5:
Attach item 6 to the existing isolator and item 5 to item 3
STEP 6:
Attach item 7 to the existing isolator and item 6 to item 3
STEP 7:
Connect slip fit on item 4 with clamp provided
STEP 8:
Ensure new exhaust is not contacting any portion of the underbody of the
vehicle or drivetrain.
STEP 9:
Tighten all clamps starting from the rear of the vehicle. (DO NOT EXCEED 30FT-
LB WHEN TIGHTENING THE CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF
NECESSARY)
WARNING
When working on, under, or around any vehicle exercise caution. Please
allow the vehicle’s exhaust system to cool before removal, as exhaust
temperatures may cause severe burns. If working without a lift, always consult
the vehicle manual for correct lifting specifications. Always wear safety
glasses and ensure a safe work area. Serious injury or death could occur if
safety measures are not followed
BRExhaust recommends professional installation for all products
Technical Support: 1-800-631-7271
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>