BRExhaust 2003-2006 Matrix Vibe 1.8L Direct Fit Exhaust Kit Instructions
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 2003-2006 Matrix Vibe 1.8L Direct Fit Exhaust Kit
Product Information:
- Product Name: Exhaust System
- Part Number: 106-0161
Installation Instructions
- Carefully read all instructions before installation.
- Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle.
- Remove the existing exhaust system from the vehicle. Only remove parts that will be replaced.
- Clean the existing flange with a wire brush to ensure proper sealing.
- Connect item 3 to existing isolators.
- Attach item 3 to existing exhaust with items 1 and 2.
- Ensure the new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
- Tighten all clamps and bolts starting from the rear of the vehicle. (DO NOT EXCEED 30FT-LB WHEN TIGHTENING THE CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)
BILL OF MATERIALS
- 167871
- 167872
- 167870
WARNING When working on, under, or around any vehicle exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.
INSTALLATION INSTRUCTIONS
- STEP 1: (Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean existing flange with a wire brush to ensure proper sealing.
- STEP 2: Connect item 3 to existing isolators
- STEP 3: Attach item 3 to existing exhaust with items 1 and 2
- STEP 4: Ensure new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
- STEP 5: Tighten all clamps and bolts starting from rear of the vehicle. (DO NOT EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)
BRExhaust recommends professional installation for all products.
Technical Support: 1-800-631-7271
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>