BRExhaust 106-0620 Direct-Fit Exhaust Kit Instructions
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 106-0620 Direct-Fit Exhaust Kit
Product Information
| Part Number | Description |
|---|---|
| 169305 | Item 1 |
| 168986 | Item 2 |
| 167506 | Item 3 |
| 168988 | Item 4 |
| 167507 | Item 5 |
| 168987 | Item 6 |
Product Usage Instructions
- Carefully read all instructions before installation.
- Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle.
- Remove the existing exhaust system from the vehicle. Only remove parts that will be replaced.
- Clean the existing flange with a wire brush to ensure proper sealing.
- Attach Item 2 to the existing exhaust with Item 1.
- Attach Item 4 to Item 2 with Item 3.
- Attach Item 6 to Item 4 with Item 5.
- Connect slip fit on Item 6 with clamp provided.
- Ensure new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
- Tighten all clamps starting from the rear of the vehicle. (DO NOT EXCEED 30FT-LB WHEN TIGHTENING THE CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)
WARNING: When working on, under, or around any vehicle exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult the vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.
BILL OF MATERIALS
- 169305
- 168986
- 167506
- 168988
- 167507
- 168987
WARNING: When working on, under, or around any vehicle exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult the vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.
INSTALLATION
-
STEP 1:
(Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove the existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean the existing flange with a wire brush to ensure proper sealing. -
STEP 2:
Attach item 2 to the existing exhaust with item 1 -
STEP 3:
Attach item 4 to item 2 with item 3 -
STEP 4:
Attach item 6 to item 4 with item 5 -
STEP 5:
Connect slip fit on item 6 with clamp provided -
STEP 6:
Ensure new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain. -
STEP 7:
Tighten all clamps starting from the rear of the vehicle. (DO NOT EXCEED 30FT- LB WHEN TIGHTENING THE CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)
BRExhaust recommends professional installation for all products
CONTACT
- Technical Support: 1-800-631-7271
- BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
- www.brexhaust.com.
- PART NO. 106-0620
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>