BRExhaust 106-0584 Direct Fit Exhaust Kit Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 106-0584 Direct Fit Exhaust Kit
Product Information
The product is an exhaust system manufactured by BRExhaust. The part number
for this specific product is 106-0584. The exhaust system comes with a bill of
materials consisting of the following items:
- 167587
- 167860
- 168911
- 167639
The installation instructions provide step-by-step guidance on how to install the exhaust system properly.
Product Usage Instructions
- Step 1: Before starting the installation process, it is crucial to read all the instructions carefully. Disconnect the vehicle’s battery to prevent electrical accidents and reset the computer if applicable to your vehicle. Remove the existing exhaust system, ensuring that only the parts that will be replaced are removed. Clean the existing flange with a wire brush to ensure proper sealing.
- Step 2: Attach item 3 to the existing exhaust and isolators using items 1 and 2.
- Step 3: Attach the tip to the outlet of item 3 and secure it after tightening the flange joint.
- Step 4: Make sure that the new exhaust system is not touching any part of the underbody of the vehicle or drivetrain.
- Step 5: Start tightening all the fasteners from the rear of the vehicle. It is important not to exceed 30 ft-lb when tightening the clamp. After driving for 50 miles, check all the clamps and retighten if necessary.
WARNING: When working on, under, or around any vehicle, exercise caution. Allow the vehicle’s exhaust system to cool down before removal, as the high temperatures can cause severe burns. If you don’t have a lift, always refer to the vehicle manual for the correct lifting specifications. Wear safety glasses and ensure a safe work area to prevent serious injury or death. BRExhaust recommends professional installation for all their products. If you require technical support, you can contact them at 1-800-631-7271. Their address is BRExhaust, 1901 Corporate Ctr, Oceanside, CA 92056. For more information, you can visit their website at www.brexhaust.com.
BILL OF MATERIALS
WARNING
When working on, under, or around any vehicle exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult the vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.
STEP 1
(Carefully read all instructions before installation) Disconnect the vehicle’s
battery before removal of the OEM exhaust system. This will prevent electrical
accidents and will reset the computer if it applies to the vehicle. Remove the
existing exhaust system from the vehicle. Only remove parts that will be
replaced. Clean the existing flange with a wire brush to ensure proper
sealing.
STEP 2
Attach item 3 to existing exhaust and isolators with items 1 and 2
STEP 3
Attach the tip to an outlet of item 3 and secure it after the flange joint is
tightened
STEP 4
Ensure the new exhaust is not contacting any portion of the underbody of the
vehicle or drivetrain.
STEP 5
Tighten all fasteners starting from the rear of the vehicle. (DO NOT EXCEED
30FT-LB WHEN TIGHTENING THE CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES.
RETIGHTEN IF NECESSARY)
BRExhaust recommends professional installation for all products Technical
Support: 1-800-631-7271 BRExhaust —
1901 Corporate Ctr, Oceanside, CA 92056
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>