BRExhaust 106-0507 Direct Fit Exhaust Kit Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 106-0507 Direct Fit Exhaust Kit
BILL OF MATERIALS:
- 168509
- 168510
- 167505
- 171685
- 171686
- 171687
- 171688
- 171684
- 103198
- 103199
- 103356
- 103358
- 103359
WARNING :
When working on, under, or around any vehicle exercise caution. Please allow
the vehicle’s exhaust system to cool before removal, as exhaust temperatures
may cause severe burns. If working without a lift, always consult vehicle
manual for correct lifting specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death could occur if safety
measures are not followed.
INSTALLATION INSTRUCTIONS
-
STEP 1:
(Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove the existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean existing flange with a wire brush to ensure proper sealing. -
STEP 2:
Attach item 1/2 to existing exhaust (nuts and bolts not included) -
STEP 3:
Connect item 4/5 to item 1/2 with item 3 -
STEP 4:
Connect item 6/7 to item 4/5 with item 3 -
STEP 5:
Connect item 8 to items 6/7 with item 3 -
STEP 6:
Connect item 9/10 to vehicle (hardware not included) -
STEP 7:
For 1998 model, use item 11 in diagram, for all other years use items 12 and 13 -
STEP 8:
Ensure new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain. -
STEP 9:
Tighten all clamps starting from rear of the vehicle. (DO NOT EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)
WARNING : BRExhaust recommends professional installation for all products.
Technical Support: 1-800-631-7271.
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056.
www.brexhaust.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>