BEGA 89019 Ceiling and Wall Luminaire Instruction Manual
- June 13, 2024
- BEGA
Table of Contents
89019 Ceiling and Wall Luminaire
Instruction Manual
89 019
Ceiling and wall luminaire for indoor use
89019 Ceiling and Wall Luminaire
Instructions for use
Application
Ceiling and wall luminaire · indoor luminaire made of hand-blown opal glass,
satin matt and metal housing, for all lighting tasks. They are ideal for
places where a soft and uniform lighting distribution is required. Luminaire
with a high protection class.
Lamp
Luminaire with screw base E 27
Lamp output max. 4 × 40 W
This product contains light sources of energy efficiency class E
Supplied lamp
4 × BEGA LED lamp 13548
LED Retrofit 7 W · 805 lm · 2700 K dimmable
Supplied lamp
4 × BEGA LED lamp 13586
LED Retrofit 7 W · 805 lm · 3000 K dimmable
Luminaire efficiency: 68%
Detailed technical and lighting data for the lamps can be found in the data
sheets on our website.
Product description
Aluminium alloy housing, finish Colour white
Hand-blown opal glass, satin matt 2 mounting holes ø 5.2 mm
Distance apart 120 mm
1 cable entry for mains supply cable
up to ø 10.5 mm max. 3 x 1.5°
Connection terminal 2.5°
Earth conductor connection
Lampholder E 27
Safety class I
Protection class IP 44
Protected against granular foreign bodies ≥ 1 mm and splash water
Impact strength IK02
Protection against mechanical impacts < 0.2 joule
– Safety mark
– Conformity mark
Weight: 3.5 kg
Safety
The installation and operation of this luminaire are subject to national
safety regulations.
Installation and commissioning may only be carried out by a qualified
electrician.
The manufacturer accepts no liability for damage caused by improper use or
installation.
If subsequent modifications are made to the luminaire, the person responsible
for these modifications shall be considered the manufacturer.
Installation
Lead the mains supply cable through the cable entry of the luminaire base.
Fix luminaire base with enclosed or any other suitable fixing material onto
the mounting surface.
Be sure to use the gasket rings supplied.
Make earth conductor connection.
Push silicone sleeves over the lines and make electrical connection.
Insert lamps.
Disassemble the rod safety clamps.
Insert the opal glass into the lower spring clips, centre and push it into the
upper spring clips.
Assemble the rod safety clamps.
Safety-rod closure
Remove one of the safety-rods and mount the glass such that the glass shoulder
fits under the remaining rod.
Re-install the removed rod and screw it into the opposite hole.
Relamping · Maintenance
Disconnect the electrical installation.
Take off glass from housing.
Clean luminaire and glass.
Use only solvent-free cleansers.
Change the lamp.
Insert glass into housing.
Spares
| Spare glass | 11 002 160 .0R G |
|---|---|
| LED lamp 2700 K | 13 548 |
| LED lamp 3000 K | 13 586 |
| Lamp holder | 63 000 052 |
BEGA Gantenbrink-Leuchten KG ·
Postfach 31 60 · 58689 Menden
· info@bega.com · www.bega.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>