BEGA 50743.6 Indoor Floor Lamp Instruction Manual
- June 13, 2024
- BEGA
Table of Contents
BEGA 50743.6 Indoor Floor Lamp
Application
Floor lamp · indoor luminaire with impact resistant synthetic diffuser and
metal housing for shielded light, deflected upwards and downwards.
Product description
- Floor lamp »STUDIO LINE«
- Metal housing, finish Colour velvet black Aluminium housing shield,
- Finish Colour velvet black
- inside hue matt copper
- Impact-resistant synthetic cover, translucent white
- Foot dimmer for infinite light adjustment
- Black cable · 2 m, with safety plug
- LED power supply unit
- 220-240 V y 50/60 Hz
- Safety class I
- c – Conformity mark
- Weight: 13.4 kg
This product contains light sources of energy efficiency class(es) D
Safety
The installation and operation of this luminaire are subject to national
safety regulations.
The manufacturer accepts no liability for damage caused by improper use or
installation. If subsequent modifications are made to
the luminaire, the person responsible for these modifications shall be
considered the manufacturer.
Overvoltage protection
The electronic components installed in the luminaire are protected against
overvoltage in accordance with DIN EN 61547.
To achieve an additional protection against
e.g. transients, etc. we recommend separate overvoltage protection components.
You can find them on our website at www.bega.com
Lamp
- Module connected wattage 43.6 W
- Luminaire connected wattage 48.5 W
- Rated temperature ta = 25 °C
- Ambient temperature ta max = 50 °C
50 7 43.6 K3
- Module designation 2x LED-1227/930
- Colour temperature 3000 K
- Colour rendering index CRI > 90
- Module luminous flux 7040 lm
- Luminaire luminous flux 2840 lm
- Luminaire luminous efficiency 58,6 lm / W
Installation
LED are high-quality electronic components! Please avoid touching the light
output opening of the LED directly during installation or relamping.
Carefully remove the floor lamp from its packaging and set it up. Make sure
that the luminaire is in a firm and secure position. Guide the luminaire
shield provided over the synthetic cover of the luminaire and adjust it in its
end position.
Connect luminaire to mains supply (230 V). Press foot dimmer gently to turn
the luminaire on or off.
Holding the sensing device enables to adjust the light intensity infinitely.
Cleaning · Maintenance
Clean luminaire regularly with solvent-free cleansers from dirt.
We recommend that you dry-clean the foot dimmer.
Replacing the LED module
The designation of the LED module is noted on a label in the luminaire.
The light colour and light output of BEGA replacement modules correspond to
those of the modules originally fitted. The module can be replaced by
qualified persons using standard tools.
Disconnect the system and open the luminaire. Please follow the installation
instructions for the LED module.
Defective luminaire cover must be replaced. Close the luminaire.
Spares
- Synthetic cover above 15 000 570
- Synthetic cover below 15 000 571
- LED power supply unit DEV-0338/1050
- Connecting cable with foot dimmer 62 001 238
- LED module 3000 K LED-1227/930
- Housing shield 71 003 356 B3
BEGA Gantenbrink-Leuchten KG · Postfach 31 60 · 58689 Menden · info@bega.com · www.bega.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>