BEGA 23013.1 Wall Luminaire for Indoor Use Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
**BEGA 23013.1 Wall Luminaire for Indoor Use Instruction Manual
**
Wall luminaire for indoor use
Instructions for use
Application
- Wall luminaire · indoor luminaire with integrated power supply unit for many lighting tasks in interior applications.
- The light emits upwards and downwards.
Product description
- Die-cast zinc luminaire housing, finish Colour white
- Crystal glass, inside white 1 cable entry for mains supply cable up to ø 10.5 mm max. 3 x 1.5@
- Connection terminal 2.5@
- Earth conductor connection
- BEGA Ultimate Driver® LED power supply unit 220-240 V x 0/50-60 Hz
- DC 176-264 V
- Safety class I
- – Safety mark
- – Conformity mark
- Weight: 0.7 kg
- This product contains light sources of energy efficiency class(es) D
Safety
- The installation and operation of this luminaire are subject to national safety regulations.
- Installation and commissioning may only be carried out by a qualified electrician.
- The manufacturer accepts no liability for damage caused by improper use or installation.
- If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.
Overvoltage protection
- The electronic components installed in the luminaire are protected against overvoltage in accordance with DIN EN 61547.
- To achieve an additional protection against e.g. transients, etc. we recommend separate overvoltage protection components.
- You can find them on our website at www.bega.com.
Lamp
- Module connected wattage: 4 W
- Luminaire connected wattage: 5.2 W
- Rated temperature: ta=25 °C
- Ambient temperature: ta max=45 °C
23 013.1K3
- Module designation: 2x LED-0234/930
- Colour temperature: 3000 K
- Colour rendering: index CRI > 90
- Module luminous flux: 610 lm
- Luminaire luminous: flux 263 lm
- Luminaire luminous efficiency: 50,6 lm/W
Installation
- LED are high-quality electronic components!
- Please avoid touching the light output opening of the LED directly during installation or relamping.
- Undo screws and lift off luminaire top.
- Lead the mains supply cable through the cable entry into the luminaire back housing.
- Note position of application “arrow down”.
- Fix luminaire back housing with enclosed or any other suitable fixing material onto the mounting surface.
- Pull silicone sleeves over the wires.
- Make earth connection and electrical connection to the terminals.
- Make earth conductor connection between luminaire top and luminaire base (plug connection).
- Note position of application “arrow down” of luminaire housing.
- Install luminaire top part, adjust it and tighten screws.
Cleaning · Maintenance
- Clean luminaire regularly with solvent-free cleansers from dirt.
- Defective glass must be replaced.
Replacement of the LED module
- The designation of the LED module is noted on a label in the luminaire.
- The light colour and light output of BEGA replacement modules correspond to those of the modules originally fitted.
- The module can be replaced by qualified persons using standard tools.
- Disconnect the system and open the luminaire.
- Please follow the installation instructions for the
- LED module.
- Defective glass must be replaced.
- Close the luminaire
Spares
- LED power supply unit: DEV-0303/350
- LED module 3000 K: LED-0234/930
2/2 BEGA Gantenbrink-Leuchten KG · Postfach 3160 · 58689 Menden · info@bega.com · www.bega.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>