UYF 98678 Wi-Fi Gateway Door Lock Instruction Manual
- June 16, 2024
- UYF
Table of Contents
98678 Wi-Fi Gateway Door Lock
Instruction Manual
98678 Wi-Fi Gateway Door Lock
Preparation Guide for Door with Existing Holes
Tools Needed
-
Measure Door Width
If the door is thinner than 1⅜ or thicker than 1¾ then the lock will not fit properly on the door. -
Measure for Backset
If existing backset is not 2⅜” or 2⅗, then the lock will not fit properly on the door. -
Measure Hole Sizes
If hole sizes are larger than those shown, then the lock will not fit properly on the door. If hole sizes are smaller than those shown, see steps 4 and 5. -
If Needed, Enlarge Hole in Door
If hole in door is smaller than 2⅛”, then use 2⅛” hole saw to enlarge hole. -
If Needed, Enlarge Hole in Door Edge if hole in lacer edge is smaller than 1″, then use 1 will bit to enlarge hole.
-
Check Strike (Door Jamb) Preparation
a. Place new strike box and strike against door jamb.
b. If strike box and strike do not fit properly, use pencil to trace around strike box and strike and mark hole positions.
c. If needed, use chisel and drill to correct door jamb preparation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>