MEEC TOOLS 009642 ASH Vacuum Cleaner Instruction Manual

MEEC TOOLS 009642 ASH Vacuum Cleaner

OPERATING INSTRUCTIONS

Important! Read the user instructions carefully before use. Save them for future reference. (Translation of the original instructions)

SAFETY INSTRUCTIONS

• Read these instructions carefully before use.
• Failure to follow all the instructions and safety instructions can result in fire, electric shock, death, personal injury and/ or material damage.
• Only use parts and accessories recommended by the manufacturer.
• Always check before use that no parts are damaged, missing or Worn and that all the safety devices are working properly.
• The product complies with all the relevant regulations for the safety of electrical equipment
• Never allow persons who are not familiar with the product, or who have not read these instructions, to use it.
• Save these instructions for future reference.
• Do not leave the product unattended when it is switched on.
• Check that the mains voltage corresponds to the rated voltage on the type plate.
• Do not carry or pull the product by the power cord.
• Do not pull the power cord to unplug the plug.
• Keep the power cord away from heat, oil and sharp edges.
• Damaged power cords increase the risk of electric shock.
• The cord must not be bent, folded, crushed or run over.
• Pull out the plug before cleaning and maintenance.
• Keep the nozzles and filter clean in good condition for best functionality and safety.
• Do not attempt to vacuum liquid.
• Do not expose the product to rain or moisture.
• Do not immerse the product in water or any other liquid.
• Do not attempt to vacuum toxic substances, hot ash, burning or red-hot objects such as matches or cigarettes, or other flammable, corrosive or explosive substances, fumes or liquids.
• The temperature of the ash must not exceed 50C.
• Only use accessories recommended by the manufacturer.
• Store the product in a clean and dry place
• If the power cord or plug are damaged they must be replaced by an authorized service center to ensure safe use.
• This product can be used by children from erght years and upwards and by persons with physical, sensorial or mental disabilities, or persons who lack experience or knowledge if they are supervised or receive instructions concerning the safe use of the product and understand the risks involved with its use. Do not allow children to play with the product.
• Cleaning and maintenance must not be carried out by children unless they are more than eight years old, and are kept under Supervision.
• Keep the product and its power cord out of the reach of children under eight years of age.
• Keep children under supervision to make sure they do not play with the product.
• Do not use the product without a filter.
• Only use a filter of the type recommended by the manufacturer (fire protection filter).

Symbols

TECHNICAL DATA

DESCRIPTION

1. Handle
2. Power switch
3. Top section
4. Container lid
5. Intake opening
6. Metal hose
7. Aluminium tube
8. Button to clean filter
9. Lock device
10.  Container
11.  Filter mode switch
12.  Motor unit
13.  Air intake, motor (metal)
14.  HEPA filter
15.  Protective grille
16.  Screw for HEPA filter 

ASSEMBLY

FITTING THE HEPA FILTER

Fit the HEPA filter on the underside of container lid and lock in place with the screw for the HEPA filter.

1. Container lid
2. HPA filter
3. Protective grille
4. Screw for HEPA filter

NOTE:
Tighten the screw so that the rubber part on the HEPA filter is firmly pressed against the red filter mode switch, otherwise the ash vacuum will not start.

Fitting accessories
Connect the metal hose and aluminium tube to the container.

USE

HOW TO USE

1. Plug in the plug.
2. To start the ash vacuum, put the power Switch in position l.
3. Put the end of the tube in the stove to be emptied ot ash.
4.  Gently sweep the tube over the ash to vacuum it up.
5. Put the power switch in position O to Switch off

Less suction power

If the suction power diminishes or the ash vacuum is less effective, this could be because the HEPA niter is clogged. Pressure five times or more on the button to clean the filter.

MAINTENANCE

1. Switch off the ash vacuum and pull out the plug.
2.  Release the hose and tube from the Container.
3. Clean the hose and tube and check they are not blocked.
4. Clean plastic parts with a damp cloth.
5. Empty the container. Adhered material can be tapped our picked off. Clean the container.
6. Brush clean or wash the fire retarding filter, in necessary.

WARNING!
Do not use detergent, solvent, or sharp or abrasive implements.

REPAIRS
Only use parts and accessories recommended by the manufacturer. Repairs should be carried out by an authorised service centre.

WASTE DISPOSAL
Recycle the product at the end of its useful life in accordance with local regulations.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>